Abstract:The steam-water separator is a crucial equipment supplying high-quality steam for the turbines in the AP1000 nuclear power station. It is comprised of the gravity separation space, primary separator (swirl-vane separator), secondary separator (wave-type vanes separator) and auxiliary equipment. In the present study, full-scale three-dimension modeling and simulation are conducted using the Euler-Lagrange approach based on the AP1000 steam generator design drawing to investigate the steam water separating mechanism and the separation performance of the AP1000 separator. The details of steam-water separation efficiency and pressure drop are obtained in the gravity separation space, primary separator and secondary separator under various operating conditions. The numerical results indicate that the separation efficiency increases rapidly as the steam velocity increases and the relative humidity at the outlet of the AP1000 steam-water separator is less than 0.1% which satisfies the design standard of the AP1000 power station. In addition, the head cover and diffuser assembly structure into the upper of the primary separator greatly increases the steam-water separation efficiency though the pressure drop increases somehow as well, compared to the geometric model without head cover and diffuser assembly. Finally, the inlet velocity distribution of the secondary separator, resulting from the arrangement of the orifice plate in front of the secondary separator, affects the separation efficiency with +/- 9% discrepancy compared to the uniform inlet distribution. (C) 2017 Elsevier Ltd. All rights reserved.

The Fabrication and Inspection of the Ultra-Supercritical Separator

Welding techniques and its application in thermal power plant

Automatic Welding System Design for Connecting Piece of Heating Surface Piping of Ultra Supercritical Boiler

Mechanical Stress Analysis of a 600 MW Supercritical Boiler Water Separator Based on the Finite Element Method

Introduction to Ultra-Supercritical Boiler Blowpipe Program

Numerical Investigation of the Separation Performance of Full-Scale AP1000 Steam-Water Separator

Microstructure and Mechanical Properties of Super304H Ultra Supercritical Pressure Boiler Superheater Tube after Serving for a Long Time

Experimental Study of A Finned Tubes Impact Gas-Solid Separator for Cfb Boilers

Steam Flow and Heat Transfer in the Intermediate Pressure Cylinder of the Ultra-Supercritical Steam Turbine

Structure modification and numerical study of the moisture-separation performance of special crossunder pipe separators for nuclear power steam turbines

The experimental system and analytical method of the flue-gas filter used in a naval supercharged boiler

Analysis and Solution of High-temperature Corrosion for a 1000 MW Ultra-supercritical Boiler

Numerical Study and Structural Optimization of Water-Wall Temperature-Measurement Device for Ultra-Supercritical Boiler

Safety analysis on cold state startup of steam separator in an ultra﹣supercritical 1 000 MW unit boiler

Investigation on slagging and high-temperature corrosion prevention and control of a 1000 MW ultra supercritical double tangentially fired boiler

Investigation of Overheating of the Final Super-Heater in a 660 MW Power Plant

Full-scale Numerical Study on the Thermal-Hydraulic Characteristics of Steam-Water Separation System in an Advanced PWR UTSG. Part Two: Droplets Separation Process

Thermal–Hydraulic Calculation and Analysis on Water Wall System of a 700 MWe Ultra-Supercritical CFB Boiler

Experimental Investigation of the Separating Characteristics of a Cyclone Separator for a W Shaped Flame-based Boiler

Computational Analysis of Tube Wall Temperature of Superheater in 1000 MW Ultra-Supercritical Boiler Based on the Inlet Thermal Deviation

Materials for ultra-supercritical coal-fired power plant boilers