Abstract:Multiple ion-doped lithium manganese oxides LiCr x Ni x Mn 2-2x O 4-z F z (0 < x ≤ 0.25, z = 0.05, 0.1) with a spinel structure and space group Fd 3 m were prepared by using the co-precipitation procedure carried out in water–alcohol solvent using adipic acid as the chelating agent. The electrochemical measurements indicated that the charge/discharge capacities of the samples prepared at 600 °C are higher than that of the treatment at 800 °C or microwave heating. The capacitance-voltage (CV) curves of LiCr x Ni x Mn 2-2x O 4-z F z (0 < x ≤ 0.25, z = 0.05, 0.1) showed that when x ≤ 0.1, the samples had two reduction–oxidation peaks at 4.0 to 4.2-V region, whereas when x > 0.1, the samples had only one reduction–oxidation peak at 4.0- to 4.2-V region in CV measurements and could offer more stable voltage plateau in a 4-V region and also had stable electrical conductivity after 20 cycles. Another reduction–oxidation peak appeared in 4.6-4.8-V region (Ni 2+ –Ni 4+ reduction–oxidation peaks); this suggests that the LiCr x Ni x Mn 2-2x O 4-z F z (0.1 < x ≤ 0.25, z = 0.05, 0.1) cathode material could offer 4.6 to 4.8-V charge/discharge plateaus, and its specific capacity increases with increasing Ni 2+ . The impedance measurements of the cell proved that the F − anion doped can not only prevent Mn 3+ from disproportion but also can prevent the passivation film from forming and can help keep stable the cell’s electrical properties. The LiCr 0.05 Ni 0.05 Mn 1.9 O 3.9 F 0.1 sintered at 600 °C shows the best cycle performance and the largest capacity in all prepared samples; its first discharge capacity is 120 mAh/g, and the discharge capacity loses only 1.78

Preparation of Cr-doped LiVPO4F and Electrochemical Studies on Li Extraction/Insertion Performances for Lithium-ion Batteries

IMPROVING THE BATTERY PERFORMANCE OF LiVPO4F BY CHROMIUM DOPING

Multi-Cations Doped Livpo4f Cathode for Lithium-Ion Batteries

Structure, Composition, and Electrochemistry of Chromium-Substituted ε-LiVOPO 4

Improving electrochemical performances of Lithium-rich oxide by cooperatively doping Cr and coating Li3PO4 as cathode material for Lithium-ion batteries

Improving electrochemical performances of Lithium-rich oxide by cooperatively doping Cr and coating Li<sub>3</sub>PO<sub>4</sub> as cathode material for Lithium-ion batteries

Improvement of Electrochemical Performance of LiFePO4 Cathode Materials for Lithium-Ion Battery

Enhanced electrochemical performance of LiVPO4F/C composite with in-situ generated Li3V2(PO4)3 for lithium-ion batteries

Improved battery performance of Fe-doped LiVPO4F with high capacity and stable cycling

Preparation and Electrochemical Performance of Modified LiNi0.5Mn1.5O4Cathode Material for Lithium-ion Batteries

Electrochemical Performance of Zr-doped Li3V2(PO4)3/C Composite Cathode Materials for Lithium Ion Batteries

Co-precipitation synthesis and performance of multi-doped LiCr x Ni x Mn 2-2x O 4-z F z cathode materials for lithium ion batteries

Electrochemical Investigations of the Lini0.45m0.10mn1.45o4 (M = Fe, Co, Cr) 5v Cathode Materials for Lithium Ion Batteries

Synthesis And Characterizations Of V-Doped Lifepo4 Cathode Materials For Rechargeable Lithium-Ion Batteries

Synthesis and electrochemical properties of Zn-doped, carbon coated lithium vanadium phosphate cathode materials for lithium-ion batteries

Electrochemical properties of Sn-doped Li 3 V 2 (PO 4 ) 3 cathode material synthesized via a citric acid assisted sol–gel method

Triple-Cation-Doped Li3V2(PO4)3 Cathode Material for Lithium Ion Batteries

Synthesis And Characterization Of Li(Li0.2mn0.4fe0.2m0.2)O-2 (M=Co, Ni, Cr, Al) Cathode Materials For Li-Ion Batteries

A novel Cu+-doped Li[Fe0.9Cu0.1Li0.1]PO4/C cathode material with enhanced electrochemical properties

Electrochemical Properties of Cr Doped V2O5 Between 3.8 V and 2.0 V

Preparation and characterization of Ti4+-doped LiFePO4 cathode materials for lithium-ion batteries