Abstract:Hybrid electric vehicle (HEV) and plug-in hybrid electric vehicle (PHEV) require high power energy sources which are inexpensive and safe. Among various battery materials, 5V LiMn1.5Ni0.5O4 spinel materials are especially of interests for these vehicle applications because of their high operating voltage of ~4.7V and because manganese is inexpensive and less toxic than Ni and Co. However, the cycle life of these cathodes is inadequate and elevated temperature cycling cause rapid loss of capacity of the LiMn1.5Ni0.5O4 cells. This capacity degradation can be attributed to dissolution of Mn and Ni elements, solid electrolyte interphase (SEI) formation and electrolyte decomposition with high-voltage cycling [1]. Metal oxide coatings, which are usually synthesized by solution-based coating techniques, have improved capacity retention of the LiMn1.5Ni0.5O4 cells at the elevated temperatures and have been usually synthesized by solution-based coating techniques [2,3]. Recently, we have successfully coated nanometer thick amorphous lithium phosphorus oxyntirde (Lipon) electrolytes on the surfaces of LiMn1.5Ni0.5O4 and LiCoO2 particles by a RFmagnetron sputtering technique [4,5]. Uniform subnanometer thick Lipon improved the cycling behaviors of LiMn1.5Ni0.5O4 cells dramatically, but did not impede the Mn dissolution. Although a thicker Lipon layers of a few nanometers were effective in preventing the Mn dissolution, the Lipon layers greatly reduced the specific capacity because Lipon has a very low electronic conductivity of ~10 -14 S/cm. For comparison, nanometerthick protective films of electronic/ionic mixed conductor are being evaluated. Half-cell performances of cathodes fabricated with LiMn1.5Ni0.5O4 particles coated with mixed conductor will be reported for cycling at room and

Electrochemical Investigations of the Lini0.45m0.10mn1.45o4 (M = Fe, Co, Cr) 5v Cathode Materials for Lithium Ion Batteries

Radially Oriented Single‐Crystal Primary Nanosheets Enable Ultrahigh Rate and Cycling Properties of LiNi0.8Co0.1Mn0.1O2 Cathode Material for Lithium‐Ion Batteries

Preparation and Electrochemical Properties of Li[Ni1/3Co1/3Mn1−x/3Zrx/3]O2 Cathode Materials for Li-ion Batteries

Investigation on performance of Li(Ni 0.5 Co 0.2 Mn 0.3 ) 1−x Ti x O 2 cathode materials for lithium-ion battery

Cycling Stability of 5V LiMn1.5Ni0.5O4 Spinel Particles Coated with a Thin Film Mixed Conductor

Synthesis And Characterization Of Li(Li0.2mn0.4fe0.2m0.2)O-2 (M=Co, Ni, Cr, Al) Cathode Materials For Li-Ion Batteries

Preparation and Electrochemical Performance of Modified LiNi0.5Mn1.5O4Cathode Material for Lithium-ion Batteries

Co-precipitation synthesis and performance of multi-doped LiCr x Ni x Mn 2-2x O 4-z F z cathode materials for lithium ion batteries

One-step Synthesis and Effect of Heat-Treatment on the Structure and Electrochemical Properties of LiNi0.5Mn1.5O4 Cathode Material for Lithium-Ion Batteries

Fe Doped Li1.2Mn0.6-x/2Ni0.2-x/2FexO2 (x≤0.1) As Cathode Materials for Lithium-Ion Batteries

Synthetic Optimization and Electrochemical Properties of LiNi_(0.5)Mn_(0.5)O_2 Cathode Materials for Lithium-ion Batteries

High-rate Performance of LiNi0.5Mn1.45Al0.05O4 Cathode Material for Lithium-Ion Batteries

Electrochemical Performances of Layered LiNi0.7CO0.3–xMxO2 (m=al, Mn, Cr; X=0.05) Cathode Materials for Rechargeable Lithium Batteries

LiNbO3 Coating and F- Doping Stabilize the Crystal Structure and Ameliorate the Interface of LiNi0.88Co0.06Mn0.03Al0.03O2 to Improve the Electrochemical Properties and Safety Capability

Correlating Cycle Performance Improvement and Structural Alleviation in LiMn2-xMxO4 Spinel Cathode Materials: A Systematic Study on the Effects of Metal-Ion Doping

Structural, Electrochemical and Thermal Stability Investigations on LiNi0.5−xAl2xMn1.5−xO4 (0 ≤ 2x ≤ 1.0) As 5 V Cathode Materials

Electrochemical and ex situ XRD studies of a LiMn1.5Ni0.5O4 high-voltage cathode material

Improving the Electrochemical Properties of High-Energy Cathode Material Lini0.5co0.2mn0.3o2 by Zr Doping and Sintering in Oxygen

Effects of Al and Co doping on the structural stability and high temperature cycling performance of LiNi0.5Mn1.5O4 spinel cathode materials

Synthesis and electrochemical performance of LiNi_(1/3)Mn_(1/3)Co_(1/3)O_2-zFz cathode materials for lithium ion batteries

Surface modification of LiNi1/3Co1/3Mn1/3O2 with Cr2O3 for lithium ion batteries