Abstract:This paper deals with the fabrication of an inductorless wideband low-noise amplifier (LNA). The LNA includes two branches in parallel: a common-source (CS) path and a common-gate (CG) path. The CS path is responsible for providing enough power gain, while the CG path is used to achieve the input impedance matching. To eliminate the noise contribution of the CG path, the noise cancellation technique is applied. Therefore, the overall noise figure (NF) is improved. The phase mismatch between the two paths is also quantitatively analyzed to investigate its effect on gain and NF. The analytical results agree well with the simulation results. The LNA has been fabricated by a commercial 0.18-mu m CMOS process. The measurement results show that the LNA has achieved a maximum gain of 14.5 dB with 1.7-GHz 3-dB gain bandwidth and a minimum NF of 3 dB. The tested input 1-dB gain compression point (IP1 dB) is -10.4 dBm at 1 GHz and the input third-order intercept point is 0.25 dBm. With 1.8-V supply, the LNA draws only 6-mA dc current.

The Design of Preamplifier Circuit Based on Weak Signal Detection

Design of signal preamplifier circuit for fluorescence detection system in quantitative PCR instrument.

Low Noise CMOS Front-End Amplifier Used in Detection of Extracellular Neural Signals (ENG)

Prefilter Design Method for Weak Signal Detection with LIA

Design of an Amplifying and Conditioning Circuit for Weak Infrared Signal

A Pre-amplifier Circuit Design for Array Induction Logging Tool(MIT 5530)

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

Design of Dual-Phase Lock-in Amplifier Used for Weak Signal Detection.

Design of Pre-Amplifiers for Photoelectric Detector

Design and Simulation of Pre-amplification Circuit for IMS Current Signals

The PLL Amplifier Design Based on Analog Multiplier

Design of Amplifying Circuit for Receiving Weak Signal for Laser Fuze

Design and Analysis of the Preamplifier of Electromagnetic Flowmeter

A Design of EES Analog Pre-processing Circuit

Design of X-band Low Noise Amplifer

Noise Analysis and Design of Preamplifier in Class D Audio Amplifier

Weak Current Detection Based On The Faims System

Optimal Design and Research of Small Signal Amplifier with Low Power Consumption

Simulation of a Preamplifier for an Extremely Weak Current Measuring Circuit

Research on preamplifiers of inductor

Design of an Ultra Wideband Low Noise Preamplifier for Single Photon Detectors