Abstract:Objective: Nuclear electronics can be applied to nuclear medicine diagnosis,providing hardware support for research in nuclear medicine.Improvement in nuclear instruments may radically facilitate the development of nuclear medicine.This work studies a basic element in nuclear electronics by circuit simulation,the charge-sensitive preamplifier,which has been widely employed in high resolution nuclear energy spectrometers.Methods: We employ EDA software such as orCAD and Pspice to simulate charge-sensitive preamplifier circuits for implementing transient analysis,noise analysis and temperature analysis.Simulation results show convincing agreement with theory.By varying circuital parameters,the output such as voltage output waveform can be observed dynamically.The output signal and noise response to working temperature changes can also be observed vividly in order to study the circuit temperature effect.Results: Primary circuital parameters including conversion gain and mean count rate agree well with theory.Leak resistance is required in order to maintain the normal work linear range by releasing accumulated charges.The distributed capacitance is the main source causing noise in preamplifier,which must be reduced to minimize noise.Output noise level will increase as a response to the rising temperature within the normal working frequency range.Conclusions: Maximizing the signal to noise ratio of detector and preamplifier is critical to the design of high resolution energy spectrometer.Care must be taken to study temperature and noise effect for designing low noise high quality preamplifier.Circuit simulation has advantages such as fast operation,observable vivid output,and the ability to separation of noise from the signal,which should be found great potential of use in designing nuclear electronics and medical instruments.

Simulation of a Preamplifier for an Extremely Weak Current Measuring Circuit

System Design of a Low Noise, Low Offset Instrumentation Amplifier with Chopper Stabilization

Design of signal preamplifier circuit for fluorescence detection system in quantitative PCR instrument.

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A 2.5 Gb/s CMOS Low Noise Transimpedance Amplifier with Active Feedback

A Miniature Transformer-Coupled Low-Noise Preamplifier for Low Source Resistance Sensors at Low Frequency

Design and Simulation of Pre-amplification Circuit for IMS Current Signals

Comprehensive Design Considerations and Noise Modeling of Preamplifier for MEMS Electrometry.

Design And Simulation Of Low Noise Amplifier For Radio Frequency Front End Of Wireless Communication

Simulation and optimization of conductor structural parameters of free-space hall-effect current sensor

A Design of EES Analog Pre-processing Circuit

Noise Analysis of A Low Noise Charge Sensitive Preamplifier

A Pre-amplifier Circuit Design for Array Induction Logging Tool(MIT 5530)

Multiparallel Differential JFET Low-Noise Amplifier Circuit Based on Discrete Current Source

An Improved Impedance Measurement Method Based on Multi-Sine Signal Considering the Suppression of Noise Interference

Miniature Optical Signal Transmission System for PDN Noise Measurement

Nuclear Instrumental Circuit Simulation in Nuclear Medicine

Weak Current Detection Based On The Faims System

A Comparative Study of the Preamplifiers in Electrostatic Sensors Through Analytical Modeling and Experimental Evaluation

A Modulation Method for Tunnel Magnetoresistance Current Sensors Noise Suppression

Analysis and design of a weak charge signal amplifier circuit