Abstract:Traditional light sources were required to provide stable and uniform illumination for a living or working environment considering performance of visual function of human being. The requirement was always reasonable until non-visual functions of the ganglion cells in the retina photosensitive layer were found. New generation of lighting technology, however, is emerging based on novel lighting materials such as LED and photobiological effects on human physiology and behavior.To realize dynamic lighting of LED whose intensity and color were adjustable to the need of photobiological effects, a quantitative dimming method based on Pulse Width Modulation (PWM) and light-mixing technology was presented. Beginning with two channels' PWM, this paper demonstrated the determinacy and limitation of PWM dimming for realizing Expected Photometric and Colorimetric Quantities (EPCQ), in accordance with the analysis on geometrical, photometric, colorimetric and electrodynamic constraints. A quantitative model which mapped the EPCQ into duty cycles was finally established. The deduced model suggested that the determinacy was a unique individuality only for two channels' and three channels' PWM, but the limitation was an inevitable commonness for multiple channels'. To examine the model, a light-mixing experiment with two kinds of white LED simulated variations of illuminance and Correlation Color Temperature (CCT) from dawn to midday. Mean deviations between theoretical values and measured values were obtained, which were 15lx and 23K respectively. Result shows that this method can effectively realize the light spectrum which has a specific requirement of EPCQ, and provides a theoretical basis and a practical way for dynamic lighting of LED.

Anomalous-Pulsewidth Modulation of Single-Contact Light-Emitting Diode for Grayscale Control

A average separated PWM dimming algorithm based on human visual feature

A Dimmable and Power-Compensated AC Direct LED Driver with High Efficiency

An Analog PWM Pixel Circuit with Shaping Function for Low Grayscale Display of Micro-LEDs

A New Pixel Circuit for Micro-Light Emitting Diode Displays with Pulse Hybrid Modulation Driving and Compensation

Improvement of the low gray-level expression using hybrid pulse width modulation and pulse amplitude modulation driving method for a micro light-emitting diode pixel circuit

A Quantitative Dimming Method for LED Based on PWM

A New Analog PWM Pixel Circuit with Metal Oxide TFTs for Micro-LED Displays

61‐4: A New Pixel Circuit Based on LTPO Backplane Technology for Micro‐LED Display Using PWM Method

A High 6318-PPI Pixel Circuit That Realizes 10-bit Gray Levels for Analog-PWM Driven Micro-LED Displays

Coplanar Electrodes Color-Tunable AC-OLEDs with Wide Operating Windows

Driving of Micro-Led and OLED Hybrid Integrated Display Devices with Opposite Polarities

P‐9: Student Poster: Two‐Mode PWM Driven Micro‐LED Displays with Dual‐Gate Metal‐Oxide TFTs

P‐23: Low Power A‐PWM Μled Pixel Circuit of Progressive‐mode Using Single Sweep Signal for Mobile Displays

Multi-grayscale Driving System for Passive-Matrix Alternating Current Electroluminescence Display

White Polymer Light-Emitting Diodes with Ultra-Large Color Shifts for Pulse-Width-modulation Applications

A Chromatic Aberration Correction Method for RGB LED Based on PWM

High Performance A-PWM Μled Pixel Circuit Design Using Double Gate Oxide TFTs

Alternating Current-Driven Quantum-Dot Light-Emitting Diodes with Planar Architecture

Optimization of Illumination Performance of Trichromatic White Light-Emitting Diode and Characterization of Its Modulation Bandwidth for Communication Applications

Sinusoidal Pulsewidth Modulation Scheme for LED Lighting to Reduce LED Flicker