Abstract:Abstract A high temperature superconducting (HTS) demonstration coil has been developed in the frame of the Experimental Physics department Research & Development program at CERN. The magnet extends the recent experimental demonstration of aluminium-stabilised HTS conductors and supports the development of future large scale detector magnets. The HTS magnet has five turns and an open bore diameter of 230 mm. Up to 30 K, the coil was measured to be fully superconducting across four central turns at 4.4 kA, the maximum available current of existing power supply. The central magnetic field is 0.113 T,the peak field on the conductor is 1.2 T and the coil has a stored magnetic energy of 0.1 kJ. A 3D-printed aluminium alloy (Al10SiMg) cylinder acts both as a stabiliser and a mechanical support for the superconductor. The resistivity of Al10SiMg was measured at cryogenic temperatures, and has a residual resistivity ratio of approximately 2.5. The ability to solder ReBCO tapes (a stack of four REBCO tapes, 4 mm wide, Fujikura) to Al10SiMg stabiliser, electroplated with copper and tin, forming a coil, is demonstrated using tin-lead solder at 188 °C. The HTS magnet was proven to be stable when superconductivity was broken locally using a thin-film heater. Despite voids in the solder joint between HTS and stabiliser, no degradation of the magnet’s performance was observed after 12 thermal cycles and locally quenching the magnet. A numerical model of the transient behaviour of solenoid with partially shorted turns is developed and validated against measurements. Our work experimentally and numerically validates that using an aluminium alloy as a stabiliser for HTS tapes can result in a stable, lightweight and transparent magnet.

Design and Testing of a Prototype Canted-Cosine-Theta HTS Dipole Magnet Using CORC Cable

Design and testing of a demonstration HTS diploe magnet

Conceptual Design of an HTS Dipole Insert Based on Bi2212 Rutherford Cable

Conceptual Mechanical Structure Analysis of A 16 T Canted Cosine Theta (CCT) Magnet

Design and Fabrication of a 13-T Twin-Aperture Superconducting Dipole Magnet with Graded Common-Coil Configuration

The Conceptual Optimal Design of a 300MJ High Temperature Superconducting Magnet

20 T Dipole Magnet Based on Hybrid HTS/LTS Cos-Theta Coils with Stress Management

Self-protected high-temperature superconducting demonstrator magnet for particle detectors

Modeling of the Stacked High-Temperature Superconducting Cable-in-Conduit Conductor for High-Field Magnet Applications

Design and Test of Superconducting Magnet for 200 MeV Proton Cyclotron

Measurement and Analysis of the Dynamic Effects in an HTS Dipole Magnet

HTS Dipole Magnet with a Mechanical Energy Transfer in the Magnetic Field

Structural Design and Mechanical Analysis of HTS CICC Made From Twisted Stack Slotted-Core Cable

Manufacture and Testing of Pre-prototype HTS Twisted Stack Slotted-Core Cable

Electromagnetic Design of HTS D-shaped Coils for a Toroidal-type Superconducting Magnet

Development of Testing Device for Critical Current Measurements for HTS/LTS

Design and analysis of a HTS internally cooled cable for the Muon Collider target and capture solenoid magnets

Conceptual Design of CEPC Detector Magnet

Simplified magnet design and manufacture based on patterning of wide conductors

Conceptual Design Study of a Test Facility Magnet for Fusion Conductor Samples

Conceptual Design of A 20 T Dipole Based on Hybrid REBCO/Nb3Sn Cos-theta Coil*