Abstract:Abstract A high temperature superconducting (HTS) demonstration coil has been developed in the frame of the Experimental Physics department Research & Development program at CERN. The magnet extends the recent experimental demonstration of aluminium-stabilised HTS conductors and supports the development of future large scale detector magnets. The HTS magnet has five turns and an open bore diameter of 230 mm. Up to 30 K, the coil was measured to be fully superconducting across four central turns at 4.4 kA, the maximum available current of existing power supply. The central magnetic field is 0.113 T,the peak field on the conductor is 1.2 T and the coil has a stored magnetic energy of 0.1 kJ. A 3D-printed aluminium alloy (Al10SiMg) cylinder acts both as a stabiliser and a mechanical support for the superconductor. The resistivity of Al10SiMg was measured at cryogenic temperatures, and has a residual resistivity ratio of approximately 2.5. The ability to solder ReBCO tapes (a stack of four REBCO tapes, 4 mm wide, Fujikura) to Al10SiMg stabiliser, electroplated with copper and tin, forming a coil, is demonstrated using tin-lead solder at 188 °C. The HTS magnet was proven to be stable when superconductivity was broken locally using a thin-film heater. Despite voids in the solder joint between HTS and stabiliser, no degradation of the magnet’s performance was observed after 12 thermal cycles and locally quenching the magnet. A numerical model of the transient behaviour of solenoid with partially shorted turns is developed and validated against measurements. Our work experimentally and numerically validates that using an aluminium alloy as a stabiliser for HTS tapes can result in a stable, lightweight and transparent magnet.

Design and testing of a demonstration HTS diploe magnet

Design and Testing of a Prototype Canted-Cosine-Theta HTS Dipole Magnet Using CORC Cable

Development of a Conduction-Cooled HTS SMES

Design and Test Performance of 2g Pancake Coils for Hts Dc Induction Heater Prototype

HTS Dipole Magnet with a Mechanical Energy Transfer in the Magnetic Field

Self-protected high-temperature superconducting demonstrator magnet for particle detectors

Electromagnetic Design of HTS D-shaped Coils for a Toroidal-type Superconducting Magnet

The Conceptual Optimal Design of a 300MJ High Temperature Superconducting Magnet

Measurement and Analysis of the Dynamic Effects in an HTS Dipole Magnet

Conceptual Design Study of a Test Facility Magnet for Fusion Conductor Samples

Development of Testing Device for Critical Current Measurements for HTS/LTS

Mechanical Design, Assembly and Strain Measurement Results of a 13-T Superconducting Dipole Magnet

Design and Operating Characteristics Analysis of HTS Magnets for Dipole-Type DC Induction Heating

Manufacture and Preliminary Prototype Test of a HTS Suspension Electromagnet for Maglevs

High Temperature Superconducting Magnet for Fast Discharging Experiments

Design and Testing of a Gas-Helium Conduction Cooled REBCO Magnet for a 300 kvar HTS Synchronous Condenser Prototype

Design and Fabrication of a 13-T Twin-Aperture Superconducting Dipole Magnet with Graded Common-Coil Configuration

Conceptual Design of an HTS Dipole Insert Based on Bi2212 Rutherford Cable

Structural analysis of superconducting dipole prototype for HIAF

A Practical Superconducting DC Dynamo for Charging Conduction-Cooled HTS Magnet

Design and Test of A Short Mockup Magnet for the Superconducting Undulator at the Ssrf