A Practical Superconducting DC Dynamo for Charging Conduction-Cooled HTS Magnet

Yujia Zhai,Chunran Mu,Jinduo Wang,Litong Zhu,Tingkun Weng,Zhuo Li,Xingzheng Wu,Liufei Shen,Jianhua Liu,Qiuliang Wang
DOI: https://doi.org/10.3390/en17112684
IF: 3.2
2024-06-01
Energies
Abstract:At present, HTS magnets cannot operate in the real closed-loop persistent current mode due to the existence of joint resistance, flux creep, and AC loss of the HTS tape. Instead of using a current source, HTS flux pumps are capable of injecting flux into closed HTS magnets without electrical contact. This paper presents a practical superconducting DC dynamo for charging a conduction-cooled HTS magnet system based on a flux-pumping technique. To minimize heat losses, the rotor is driven by a servo motor mounted outside the vacuum dewar by utilizing magnetic fluid dynamic sealing. Different parameters, such as air gap and rotating speed, have been tested to investigate the best pumping effect, and finally, it successfully powers a 27.3 mH HTS non-insulated double-pancake coil to the current of 54.2 A within 76 min. As a low-cost and compact substitute for the traditional current source, the realization of a contactless DC power supply can significantly improve the flexibility and mobility of the HTS magnet system and could be of great significance for the technological innovation of future HTS magnets used in offshore wind turbines, biomedical, aerospace, etc.
energy & fuels
What problem does this paper attempt to address?
The problem that this paper attempts to solve is the challenges faced in achieving a true closed - loop persistent current mode (PCM) operation in high - temperature superconducting magnets (HTS magnets). Due to the existence of joint resistance, flux creep and AC loss in HTS tapes, these factors cause the current attenuation when HTS magnets operate in the superconducting state. Traditional current sources are bulky and require current leads connected to the cryogenic environment, which not only increases the thermal leakage of the system but also limits the application and development of HTS magnets. To solve these problems, the paper proposes a practical superconducting DC generator based on the flux - pumping technique for charging conduction - cooled HTS magnets. This non - contact DC power supply device can significantly improve the flexibility and mobility of the HTS magnet system and is of great significance for the technological innovation of HTS magnets applied in offshore wind power generation, biomedicine, aerospace and other fields in the future. Specifically, the main objectives of the paper include: 1. **Reduce heat loss**: By moving the heat - generating components out of the vacuum Dewar flask and using the magnetohydrodynamic sealing technology to drive the rotor, thereby reducing heat loss. 2. **Optimize the flux - pumping effect**: Test different parameters (such as air gap and rotation speed) to find the best pumping effect. 3. **Achieve efficient charging**: Successfully charge a non - insulated double - pancake coil of 27.3 mH to 54.2 A in only 76 minutes. Through the achievement of these objectives, the paper aims to provide a compact, low - cost and efficient charging solution for future HTS magnets.