Abstract:In this study, the near-surface physicochemical properties of low-energy nitrogen-implanted polycrystalline diamond (PCD) and their evolution with the annealing temperature were investigated. The nitrogen concentration, its chemical state, and defects created in the PCD near-surface upon 1 keV N2 + implantation at different doses of 6 × 1013 (D1), 3 × 1014 (D2), 3 × 1015 (D3), and 1 × 1016 (D4) N2 +/cm2 at room temperature were investigated up to annealing temperatures of 1000 °C. These studies were carried out using X-ray photoelectron spectroscopy (XPS), high-resolution electron energy loss spectroscopy, and thermal-programmed desorption (TPD). The highest nitrogen retention ratio was measured for D1, followed by the D2 case. It was found that the implanted nitrogen near-surface concentration obtained similar values for the D3 and D4 cases. From the C(1s) and N(1s) XP line shape analysis, it is determined that upon D1 implantation, nitrogen is bonded into interstitial sites in mostly a single-bonding configuration, C–N\CN, and very low levels of point defects are produced by the implantation process. As the dose increases to D2, nitrogen bonding also occurs to point defects, creating a low concentration of CN (nitrile-like) bonds. For D3 and D4 cases, the near-surface region is fully amorphized/graphitized, and the implanted nitrogen is bonded in a multitude of bonding configurations characteristic of nitrogen bonded to a disordered graphitic structure. The TPD measurements show that N2 and HCN are the main desorption species and their desorption rate depends on implantation dose and surface temperature. Hydrogen was found to be chemically bonded with surface carbon atoms as well as to some of the implanted nitrogen. From the C(1s) XP line shape analysis, it is determined that for D1, only point defects were created upon implantation, which cannot be annealed within the temperature range used in the present study. For the higher doses, the density of defects increases, and a graphitic layer is found to evolve with annealing temperature. It was found that upon annealing, the relative concentration of different nitrogen states formed varies alongside the relaxation of the disordered carbon layer, suggesting the possibility of complex chemical processes involving diffusion, desorption, and interconversion between the implanted species.

The Near Surface Damage and Recovery of Low Nitrogen Diamond Implanted with Mev Phosphorus Ions

The Luminescence Study of GeV Centers and Damage in Diamond Induced by 300kev Ge Ion Implantation

Effects of Vacancy and Hydrogen on the Growth and Morphology of N-Type Phosphorus-Doped Diamond Surfaces

Influence of 1 keV N 2 + Implantation on Nitrogen Bonding, Defect Formation, and Thermal Stability of the Polycrystalline Diamond Near-Surface Region Studied by XPS, TPD, and HREELS

Dynamic annealing assisted near-surface structural and bond stabilization in high-temperature low-energy N2+ implanted diamond

Effect of Low-Damage Inductively Coupled Plasma on Shallow NV Centers in Diamond

Photoluminescence Studies of the Charge States of Nitrogen Vacancy Centers in Diamond after Arsenic Ion Implantation and Subsequent Annealing

Photoluminescence decomposition analysis: a technique to characterize NV creation in diamond

Diamond Processing by Focused Ion Beam - Surface Damage and Recovery

Effect of Low-Damage Inductively Coupled Plasma on Shallow Nitrogen-Vacancy Centers in Diamond

Optical and electronic properties of sub-surface conducting layers in diamond created by MeV B-implantation at elevated temperatures

Can surface-transfer doping and UV irradiation during annealing improve shallow implanted Nitrogen-Vacancy centers in diamond?

Subsurface nitrogen bonding, thermal stability, and retention of 200 eV N 2 + implanted polycrystalline diamond studied by in situ X-ray photoelectron spectroscopy

Radiation Damage Effects on Optical, Electrical, and Thermophysical Properties of CVD Diamond Films

Effects of phosphorus doping via Mn3P2 on diamond growth along the (100) surfaces

Characterization of Single Crystal Diamond Damaged Layer Induced by Ion Implantation and Restored by Varying Annealing Conditions

Optical Defects and Their Depth Penetration in 200 Kev Electron Irradiated IIa Diamond

Impact of surface and laser-induced noise on the spectral stability of implanted nitrogen-vacancy centers in diamond

Dopant-assisted stabilization of negatively charged single nitrogen-vacancy centers in phosphorus-doped diamond at low temperatures

Creation of NV centers in diamond under 155 MeV electron irradiation

Diamond-defect engineering of NV- centers using ion beam irradiation