Abstract:A mathematical model is necessary to analyze sensor performance and optimize its design. However, most of the existing models of piezoelectric micro-machined hydrophones are incomplete and too complex to understand. There has been no mathematical model for the sensitivity of piezoelectric hydrophones. To address this shortcoming, this paper proposes a mathematical model of a piezoelectric micro-machined hydrophone. The stresses in the piezoelectric layer and static displacement of the diaphragm under uniform sound pressure are derived. In addition, the resonant frequency and sensitivity of the hydrophone are analyzed. The finite element simulation is used to verify the validity of the proposed mathematical model. On the basis of the mathematical model and simulation, the diaphragm radius, top electrode area, and piezoelectric film thickness are optimized. Furthermore, the hydrophone is fabricated, and its morphology is observed. The impedance-frequency spectrum of the hydrophone is measured by HIOKI IM3536 LCR impedance analyzer. The tested resonant frequency is 0.5 MHz, which is relatively close to the calculated result of 0.537 MHz, so the validity of the proposed mathematical model is further validated. Also, the reason why the test result is less than the calculated result is explained. The effective electromechanical coupling coefficient derived from the impedance curve is 7.5%. The developed mathematical model can provide a useful guide for designing high performance piezoelectric micromachined hydrophone and make preliminary predictions of its characteristics.

Simulation Study on Optimization Design of MEMS Hydrophone Based on AlN Film

Design and Characterization of an Aluminum Nitride-Based MEMS Hydrophone With Biologically Honeycomb Architecture

A Piezoelectric AlN MEMS Hydrophone with High Sensitivity and Low Noise Density

Simulation and Optimization of Piezoelectric Micromachined Ultrasonic Transducer Unit Based on AlN

Design, Fabrication, Characterization, and Simulation of AlN-Based Piezoelectric Micromachined Ultrasonic Transducer for Sonar Imaging Applications

Design, Fabrication, Characterization and Simulation of AlN PMUT for Sonar Imaging Applications

Research on the Nested Package Structure of a MEMS Vector Hydrophone

A High-Performance 9.5% Scandium-Doped Aluminum Nitride Piezoelectric MEMS Hydrophone With Honeycomb Structure

High speed surface acoustic wave and laterally excited bulk wave resonator based on single-crystal non-polar AlN film

A Novel MEMS Based Piezoresistive Vector Hydrophone for Low Frequency Detection

A Mathematical Model of a Piezoelectric Micro- Machined Hydrophone With Simulation and Experimental Validation

Fabrication and Characterization of AlN-based, CMOS compatible Piezo-MEMS Devices

Design of the Monolithic Integrated Array MEMS Hydrophone

Membraneless Piezoelectric MEMS speakers based on AlN Thin Film

Design Study on SAW Devices Based on ZnO/Si Structure

CMOS-Integrated Aluminum Nitride MEMS: A Review

Flexible Surface Acoustic Wave Device with Aln Film on Polymer Substrate

Preparation, Characterization, and Application of AlN/ScAlN Composite Thin Films

AlScN-Based Dual-Mode Devices With Temperature Compensated Strategy and Process Optimization

Design and Fabrication of High-Performance Piezoelectric Micromachined Ultrasonic Transducers Based on Aluminum Nitride Thin Films