Abstract:Abstract This paper presents 3D Fabry–Pérot (FP) cavities fabricated directly onto cleaved ends of low-loss optical fibers by a two-photon polymerization (2PP) process. This fabrication technique is quick, simple, and inexpensive compared to planar microfabrication processes, which enables rapid prototyping and the ability to adapt to new requirements. These devices also utilize true 3D design freedom, facilitating the realization of microscale optical elements with challenging geometries. Three different device types were fabricated and evaluated: an unreleased single-cavity device, a released dual-cavity device, and a released hemispherical mirror dual-cavity device. Each iteration improved the quality of the FP cavity’s reflection spectrum. The unreleased device demonstrated an extinction ratio around 1.90, the released device achieved 61, and the hemispherical device achieved 253, providing a strong signal to observe changes in the free spectral range of the device’s reflection response. The reflectance of the photopolymer was also estimated to be between 0.2 and 0.3 over the spectrum of interest. The dual-cavity devices include both an open cavity, which can interact with an interstitial medium, and a second solid cavity, which provides a static reference reflection. The hemispherical dual-cavity device further improves the quality of the reflection signal with a more consistent resonance, and reduced sensitivity to misalignment. These advanced features, which are very challenging to realize with traditional planar microfabrication techniques, are fabricated in a single patterning step. The usability of these FP cavities as thermal radiation sensors with excellent linear response and sensitivity over a broad range of temperature is reported. The 3D structuring capability the 2PP process has enabled the creation of a suspended FP heat sensor that exhibited linear response over the temperature range of 20 oC –120 oC; temperature sensitivity of ∼50 pm oC −1 at around 1550 nm wavelength; and sensitivity improvement of better than 9x of the solidly-mounted sensors.

Polymer Microtip Bridge Between Two Optical Fibers Integrated in a V-Groove

Splicing Optical Microfibers Via Polymer Nanowires

Microfiber Resonator in Polymer Matrix.

A Simple Approach to Fiber-Based Tunable Microcavity with High Coupling Efficiency

Photopolymer Microtips for Efficient Light Coupling Between Single-Mode Fibers and Small-Core Photonic Crystal Fibers

Polymer Micro or Nanofibers for Optical Device Applications

Bessel-like Beams Generated Via Fiber-Based Polymer Microtips

Multifunctional integration on optical fiber tips: challenges and opportunities

Protruding-shaped SiO2-microtip: from Fabrication Innovation to Microphotonic Device Construction

All‐Dielectric Fiber Meta‐Tip Enabling Vortex Generation and Beam Collimation for Optical Interconnect

Three-dimensional Fabry–Pérot cavities sculpted on fiber tips using a multiphoton polymerization process

Flexible Passive Integrated Photonic Devices with Superior Optical and Mechanical Performance.

A Polymer-Based Surface Grating Coupler with an Embedded Si3n4 Layer

Through-Fiber Drawing of Microwires: an Online Photonic Bridge

Integrative Optofluidic Microcavity with Tubular Channels and Coupled Waveguides Via Two-Photon Polymerization

Microstructures Made in Optical Fiber with Femtosecond Laser

Mechanically tunable integrated beamsplitters on a flexible polymer platform

Optical Microfibers Integrated with Evanescent Field Triggered Self-Growing Polymer Nanofilms.

All‐Dielectric Fiber Meta‐Tip for Alignment‐Tolerant Bidirectional Interconnect Between Single‐Mode and Multi‐Mode Fibers

A Hybrid Self-Growing Polymer Microtip for Ultracompact and Fast Fiber Humidity Sensing

Vertical Coupling Between Waveguides and Optical Fibers Utilizing Polarization Gratings