Abstract:Abstract This paper presents 3D Fabry–Pérot (FP) cavities fabricated directly onto cleaved ends of low-loss optical fibers by a two-photon polymerization (2PP) process. This fabrication technique is quick, simple, and inexpensive compared to planar microfabrication processes, which enables rapid prototyping and the ability to adapt to new requirements. These devices also utilize true 3D design freedom, facilitating the realization of microscale optical elements with challenging geometries. Three different device types were fabricated and evaluated: an unreleased single-cavity device, a released dual-cavity device, and a released hemispherical mirror dual-cavity device. Each iteration improved the quality of the FP cavity’s reflection spectrum. The unreleased device demonstrated an extinction ratio around 1.90, the released device achieved 61, and the hemispherical device achieved 253, providing a strong signal to observe changes in the free spectral range of the device’s reflection response. The reflectance of the photopolymer was also estimated to be between 0.2 and 0.3 over the spectrum of interest. The dual-cavity devices include both an open cavity, which can interact with an interstitial medium, and a second solid cavity, which provides a static reference reflection. The hemispherical dual-cavity device further improves the quality of the reflection signal with a more consistent resonance, and reduced sensitivity to misalignment. These advanced features, which are very challenging to realize with traditional planar microfabrication techniques, are fabricated in a single patterning step. The usability of these FP cavities as thermal radiation sensors with excellent linear response and sensitivity over a broad range of temperature is reported. The 3D structuring capability the 2PP process has enabled the creation of a suspended FP heat sensor that exhibited linear response over the temperature range of 20 oC –120 oC; temperature sensitivity of ∼50 pm oC −1 at around 1550 nm wavelength; and sensitivity improvement of better than 9x of the solidly-mounted sensors.

Photopolymer Microtips for Efficient Light Coupling Between Single-Mode Fibers and Small-Core Photonic Crystal Fibers

A Simple Approach to Fiber-Based Tunable Microcavity with High Coupling Efficiency

Toward On-Chip Unidirectional and Single-Mode Polymer Microlaser

A Tiny In-Line Coupler Tip With the Half Tapered Dual-Core Photonic Crystal Fibre

Extremely High-Efficiency Coupling Method for Hollow-Core Photonic Crystal Fiber

Three-dimensional Fabry–Pérot cavities sculpted on fiber tips using a multiphoton polymerization process

Polymer Microtip Bridge Between Two Optical Fibers Integrated in a V-Groove

Photonic Crystal Cavities in Microfibers with Modest Finesse and Wavelength Scale Mode Volume

Single-to-four Core Optical Fiber Coupling Using a Two-photon Polymerization Produced Waveguide

Polymer Micro or Nanofibers for Optical Device Applications

Research on Coupler of Single Mode Fiber with Photonic Crystal Fiber

Enhanced Spatial Light Coupling Efficiency of Polymer Optical Fiber via Micro-lens Self-heating Melting Technique

Dual Self-Growing Polymer Microtips on A Multicore Fiber for Humidity and Temperature Discriminative Sensing

Low-Loss Coupling Between Tapered Fibers and Anti-Resonant Hollow-Core Photonic Crystal Fibers

Improved photopolymerization for fabricating fiber optical tweezers

An Optimized Design of a Dual-Core Photonic Crystal Fiber Coupler

Efficient coupling between an integrated photonic waveguide and an optical fiber

Integrated Hollow-Core Fibers for Nonlinear Optofluidic Applications

WGM Micro-Fluidic-Channel Based on Reflection Type Fiber-Tip-Coupled Hollow-Core PCFs

Coupling efficiency of a laser diode to a single-mode fiber via a microlens on the fiber tip

In-Fiber Butt-Coupled Spherical Microcavity with Whispering Gallery Mode and Fabry-Perot Resonances