Abstract:With the rapid development of electronic technology, the required heat dissipation capacities of electronic chips are increasing. In this study, a thermal management strategy for electronic chips based on a combination of a flat-plate heat pipe (FPHP) and spray cooling was designed to improve the heat dissipation performance of the condensation section of the heat pipes. Experiments were conducted to investigate the start-up characteristics of the FPHP, as well as the effects of the inlet temperature and the spray flow rate on the overall heat transfer performance. The best comprehensive performance of the FPHP and spray cooling was obtained when the heat flux was 20–40 W/cm2. In this heat-flux range, the heat pipe had the lowest thermal resistance and the highest thermal conductivity, and the corresponding spray heat transfer coefficient was 168.4 kW/(m2•K), which was significantly higher than those for traditional air-cooled (0.02∼0.1 kW/(m2•K)) and water-cooled radiators (1∼10 kW/(m2•K)). Within a certain range, a higher inlet temperature corresponded to a shorter start-up time of the heat pipe, and the effect of inlet temperature on the heat transfer uniformity of the heat pipe was negligible. Moreover, when the heat flux was less than 30 W/cm2, increasing the inlet temperature would help increase the temperature difference between the evaporation surface and the condensation surface of the heat pipe, and improved the heat transfer performance of FPHP. But when the heat flux was greater than 30 W/cm2, the higher the inlet temperature, the higher the amount of steam in the vapor chamber, the greater the thermal resistance, and the worse the heat transfer performance of FPHP. Increasing the inlet temperature of the cooling medium caused the droplets to vaporise at the entrance of the nozzle in advance, weakening the dissipation effect of the spray cooling. The combination of the heat pipe and spray cooling provides a novel idea for electronic thermal management technology, that is, using two or more cooling technologies to adapt to diverse applications.

Cooling of Power Electronic Devices Using Rectangular Flat Heat Pipes with Externally and Internally Cooled Condenser Regions

Simulation of Steady-State Operation of an Ejector-Assisted Loop Heat Pipe with a Flat Evaporator for Application in Electronic Cooling

Experimental Study of Composite Heat Pipe Radiator in Thermal Management of Electronic Components

Experimental investigation on thermal performance of ultra-thin flattened heat pipe with middle heating for electronics cooling

Liquid Plug Characteristics and Heat Transfer Performance of a Silicon-Based Ultra-Thin Flat Heat Pipe at Different Incline Angles

Experimental Research on Heat Transfer Performance of Novel Radial Flat Heat Pipe

Mini-scale pulsating heat pipe cooling systems for high-heat-flux electronic equipment

Experimental Study on the Thermal Performance of Flat Loop Heat Pipe Applied in Data Center Cooling

Thermal management strategy for electronic chips based on combination of a flat-plate heat pipe and spray cooling

Experimental Study on Heat Transfer Performance Using a Hybrid Cooling Method Combined of a Flat-Plate Heat Pipe and Spray Cooling

Energy Analysis of Flattened Heat Pipe with Nanofluids for Sustainable Electronic Cooling Applications

Fabrication and Performance Evaluation of Flexible Heat Pipes for Potential Thermal Control of Foldable Electronics

Thermal study of the natural air cooling using roll bond flat heat pipe as plate fin under multi-heat source condition

Visualization study of a flat confined loop heat pipe for electronic devices cooling

Effect of Key Structure and Working Condition Parameters on a Compact Flat-Evaporator Loop Heat Pipe for Chip Cooling of Data Centers

Study of a new thin flat loop heat pipe for electronics

Self-Convectional Three-Dimensional Integrated Circuit Cooling System using Micro Flat Heat Pipe for Portable Devices

Experimental investigation on thermal performance of pulsating heat pipe by using Dowtherm – A

Experimental study of flat-disk loop heat pipe with R1233zd(E) for cooling terrestrial electronics

Thermal Characteristic of a Novel Flat Plate Heat Pipe for Hybrid Integrated Power Electronic Module

Experimental Investigation on the Thermal Performances of a New Design of Pulsating Heat Pipe With Two Condensers