Abstract:Silicon -based ultra -thin flat heat pipes (UFHPs) that can be integrated with semiconductor devices provide an opportunity for electronic thermal management. To meet the requirements of various operation states, the impacts of gravity on the liquid plug characteristics and heat transfer performance of an UFHP are investigated by a visualization experiment conducted at different incline angles. Condensate flows back through microgrooves under the capillary pressure and gravity under a low heating power (capillary flow stage), and then excess condensate flows back along the edges of the UFHP under a higher heating power (gravitational flow stage). Over a certain heating power ( Q >= 14 W), liquid plug fluctuations caused by vapor entrainment are observed with periodic dry -out at the evaporator under large incline angles ( alpha >= 60 degrees ), corresponding to temperature fluctuations. Intense fluctuations of the liquid plug enhance sensible heat transfer, although the liquid plug occupies the condenser area and impedes the vapor flow. Meanwhile, evaporation at the evaporator benefits from corner -film evaporation until a large area of dry -out occurs. Due to the increased gravity and buoyancy, a larger incline angle is conducive to thermal performance enhancement, but this effect becomes restricted as the heating power rises. At a cooling -water temperature of 20 degrees C and an incline angle of 90 degrees , the lowest thermal resistances of the UFHP yield a value of 1.14 degrees C/W at 4 W in the steady stage and a value of 1.22 degrees C/W at 18 W in the fluctuation stage, respectively. The heat transfer limit of UFHP with overfilling reaches 24 W, compared with the theoretical heat transfer capacity of 8.9 W at an incline angle of 90 degrees . Additionally, a higher cooling -water temperature is beneficial for the thermal performance in the capillary flow stage, but not in the gravitational flow stage and fluctuation stage. This study provides guidance for the operational design of silicon -based UFHP for electronic thermal management.

Effect of Key Structure and Working Condition Parameters on a Compact Flat-Evaporator Loop Heat Pipe for Chip Cooling of Data Centers

Experimental Study on High-efficient Evaporator in Large Quick-freeze Equipment

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Experimental Study on the Thermal Performance of Flat Loop Heat Pipe Applied in Data Center Cooling

Simulation of Steady-State Operation of an Ejector-Assisted Loop Heat Pipe with a Flat Evaporator for Application in Electronic Cooling

Analytical Modeling of Forced-Air Cooling Heatsink by Considering Air Temperature Rise in Channel and Coupling of Multiple Heat Sources

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

Experimental Study on a Pump Driven Loop-Heat Pipe for Data Center Cooling

Experimental and Numerical Investigation on a CO2 Loop Thermosyphon for Free Cooling of Data Centers

Numerical investigation on transient and steady phase change heat transfer in the evaporator of a loop heat pipe

Experimental study on the thermal performance of a liquid-cooled heat sink integrating heat pipes for dual CPU servers

Study of extreme condition of heat pipe backboard system in data center

Liquid Plug Characteristics and Heat Transfer Performance of a Silicon-Based Ultra-Thin Flat Heat Pipe at Different Incline Angles

Visualization study of a flat confined loop heat pipe for electronic devices cooling

Study of Heat Dissipation Characteristics of Loop Heat Pipe with Heat Sink of Composite Material

Experimental and simulation study on flow heat transfer characteristics of flat pulsating heat pipe with wide and narrow interphase channels

Development and Analysis of a Pump-Driven Loop Heat Pipe Unit for Cooling a Small Data Center

Experimental Investigation Thermal Performance of Loop Heat Pipe Operating with Different Working Fluids

Experimental investigation on the thermal performance of a novel loop heat pipe (LHP) with micro-channel structure

Experimental Research and Energy Effectiveness Analysis on Chip-Level Two-Stage Loop Thermosyphon System for Data Centre Free Cooling

A Combined Cooling Solution for High Heat Density Data Centers Using Multi-Stage Heat Pipe Loops