Abstract:With the rapid development of electronic technology, the required heat dissipation capacities of electronic chips are increasing. In this study, a thermal management strategy for electronic chips based on a combination of a flat-plate heat pipe (FPHP) and spray cooling was designed to improve the heat dissipation performance of the condensation section of the heat pipes. Experiments were conducted to investigate the start-up characteristics of the FPHP, as well as the effects of the inlet temperature and the spray flow rate on the overall heat transfer performance. The best comprehensive performance of the FPHP and spray cooling was obtained when the heat flux was 20–40 W/cm2. In this heat-flux range, the heat pipe had the lowest thermal resistance and the highest thermal conductivity, and the corresponding spray heat transfer coefficient was 168.4 kW/(m2•K), which was significantly higher than those for traditional air-cooled (0.02∼0.1 kW/(m2•K)) and water-cooled radiators (1∼10 kW/(m2•K)). Within a certain range, a higher inlet temperature corresponded to a shorter start-up time of the heat pipe, and the effect of inlet temperature on the heat transfer uniformity of the heat pipe was negligible. Moreover, when the heat flux was less than 30 W/cm2, increasing the inlet temperature would help increase the temperature difference between the evaporation surface and the condensation surface of the heat pipe, and improved the heat transfer performance of FPHP. But when the heat flux was greater than 30 W/cm2, the higher the inlet temperature, the higher the amount of steam in the vapor chamber, the greater the thermal resistance, and the worse the heat transfer performance of FPHP. Increasing the inlet temperature of the cooling medium caused the droplets to vaporise at the entrance of the nozzle in advance, weakening the dissipation effect of the spray cooling. The combination of the heat pipe and spray cooling provides a novel idea for electronic thermal management technology, that is, using two or more cooling technologies to adapt to diverse applications.

Experimental investigation on thermal performance of ultra-thin flattened heat pipe with middle heating for electronics cooling

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Simulation of Steady-State Operation of an Ejector-Assisted Loop Heat Pipe with a Flat Evaporator for Application in Electronic Cooling

Experimental study on the thermal performance of ultra-thin flat heat pipes with novel multiscale striped composite wick structures

Study on heat transfer characteristics of ultra-thin flat heat pipes at different liquid filling rates and heat loads

Liquid Plug Characteristics and Heat Transfer Performance of a Silicon-Based Ultra-Thin Flat Heat Pipe at Different Incline Angles

Experimental investigation on a 0.5-metre-long aluminum flat heat pipe for thermal management in electronic devices

Thermal performance enhancement of an ultra-thin flattened heat pipe with multiple wick structure

Heat Transfer Capacity Optimization Design of Microgroove and Microcolumn in an Ultra-Thin Flat Heat Pipe

An Experimental Study of a Composite Wick Structure for Ultra-Thin Flattened Heat Pipes

Experimental Study of Composite Heat Pipe Radiator in Thermal Management of Electronic Components

Experimental study on the thermal performance of a liquid-cooled heat sink integrating heat pipes for dual CPU servers

Comprehensive optimization design of ultra-thin flat heat pipe based on pressure-bearing and heat transfer performance

Thermal management strategy for electronic chips based on combination of a flat-plate heat pipe and spray cooling

Investigation on Transient Behaviors of Flat Plate Heat Pipes

Visualization study of a flat confined loop heat pipe for electronic devices cooling

Experimental Study on the Thermal Performance of Flat Loop Heat Pipe Applied in Data Center Cooling

Experimental Study on Heat Transfer Performance Using a Hybrid Cooling Method Combined of a Flat-Plate Heat Pipe and Spray Cooling

Experiments and comparisons of three miniature heat pipes' thermal performance

Study on heat transfer characteristics of a dual-evaporator ultra-thin loop heat pipe for laptop cooling