Abstract:The influence of rheological properties, especially melt strength, on foam structures, such as cell size, cell density and cell size distribution, of amorphous polymer was investigated. The rheology of polystyrene (PS) was controlled by molecular modification with free radical reaction, and PS with long chain branching (LCB) level ranging from 0.15 to 1.6 branching point per 104 carbon atom was gotten. The shear and elongational rheology were found to be dependent on the LCB structure, and the strain hardening behavior of modified samples in transient elongational viscosity confirmed the existence of long branched chain. The effects of chain structure and foaming conditions such as temperature and pressure were studied by the analysis on the foam structures obtained by supercritical CO2. The experimental results revealed that increasing LCB level would decrease cell size, make cell size distribution narrower and slightly increase cell density. The effects of chain topology on the foam structures were also investigated by numerical simulation, where Pom–Pom model was used to describe the effect of backbone length and arm length. The dependence of cell size on the arm length was consistently observed in experiments and simulation. It suggested that the arm length had greater influence on the cell radius than the backbone length. Therefore, the relationship among foam structures, rheological properties and molecular structures can be established from both experiments and simulation, which can be used as a guidance to control the foam structure by designing and controlling the molecular structures and the corresponding rheological properties.

Cell Morphology and Open-cell Behavior of PS in Compound Force Field

Study on the Foaming Behaviors of PBS and its Modification with PA6IcoT Assisted by scCO2

The Study on Open-Celled Morphology of Polymer Blends in Vibration

Research on the Tensile Properties of Microcellular PS with Supercritical CO2

Fabrication of Polystyrene/nano‐caco3 Foams with Unimodal or Bimodal Cell Structure from Extrusion Foaming Using Supercritical Carbon Dioxide

Microcellular processing and relaxation of poly(ether ether ketone)

Microstructure and Properties of Microcellular Poly (phenylene Sulfide) Foams by Mucell Injection Molding

Preparation, Characterization, and Mechanical Properties of Microcellular Poly(Aryl Ether Ketone) Foams

Study of Vibration Field on Microcellular Foaming in Nucleating Agents

Preparation of Open-Cell Polymer Foams by CO2 Assisted Foaming of Polymer Blends

Formation Mechanism of Bi-modal Cell Structure Polystyrene Foams by Synergistic Effect of CO2-philic Additive and Co-blowing Agent

Foaming behavior of the multilayered ps / pa 6 blend and its anisotropic mechacical properties

Tensile and Impact Behavior of Polystyrene Microcellular Foams with Bi-Modal Cell Morphology

Preparation and characterization of microcellular injection molded foams from high-performance blends based on PPS-modified PPBESK

Study on Extrusion Foaming of Polypropylene/Polydimethylsiloxane Blends

Deformation and Simulation of the Cellular Structure of Foamed Polypropylene Composites

In-Situ Visualization of the Cell Formation Process of Foamed Polypropylene under Different Foaming Environments

Controlling cellular morphology by supercritical carbon dioxide

Comprehensive analysis of mechanical properties of microcellular polypropylene: Experiment and simulation

Rheological control in foaming polymeric materials: I. Amorphous polymers

Unprecedented cell structure variation in multilayered alternating PS/PMMA foams