Abstract:The central deformation extent of the thick plate can be improved and the approaching uniform deformation will be realized by the snake/gradient temperature rolling (SGTR). At present, the existing rolling force analytical models cannot be directly used for SGTR because of the great difference with the synchronous rolling. The rolling force model should be established so as to meet the production demand of the SGTR with different roll diameters. The thick plate is divided into three layers according to the numerical results of the short-term ultra-fast cooling for the thick plate. The deformation region is simplified into different zones and layers according to the temperature gradient and neutral point position. The traditional von Mises yield criterion was optimized by the introduced coefficients c1 and c2 according to the slip line field theory to correct the deviation caused by the uniform and shear stress assumption. The specific pressure equation is established by the slab method. The deformation region with different composition cases is analyzed, and the rolling force and torque analytical models are established according to the boundary conditions on this basis. The short-term ultra-fast cooling and rolling process were simulated by ANSYS software. The deformation resistance gradient produced by short-term ultra-fast cooling and roll diameter ratio are the main factors to affect the rolling force, while the roll offset has little effect on the rolling force because of its small proportion in the deformation region. The position of neutral points not only affects the rolling torque, but also changes its direction in certain conditions. The model precision was analyzed, and the rolling force calculated by the established analytic model is in good agreement with the numerical method, which serves as a theoretical basis for the rolling mill design and process parameter setting.

Model of Head Sag of Round Bars in Rolling Process

Study on near-net forming technology for bars by axial feed skew rolling based on taper-end billets

Model of Metal Microstructure Evolution Considering Shear Effect and Its Simulation Application in Rolling of Heavy Cylinders

Theoretical Study of Asymmetric Bending Force on Metal Deformation in Cold Rolling

Analytical and Finite Element Analysis of the Rolling Force for the Three-Roller Cylindrical Bending Process

Damage Initiation of 15V38 Steel Bar during Square‐to‐Round Hot Rolling Process

Research on the deflection of metal bar with V-shaped notch in low-stress cropping process

Theoretical Modeling and Verification of Roll-shearing Force of Thick Hollow Hexagonal Stainless Steel Tube

An analytical model of plate rolling force with a simple available velocity field and equal perimeter yield criterion

Research on bar deflection of low-stress cropping process under bending-shear coupling effect

The central strain analytical modeling and analysis for the plate rolling process

Modeling of the ductile damage – Application for bar shearing

Finite element analysis on shape deformation of the macro‐structure region during hot‐rolling process for gear steel FAS3420H and its modification

Research on the analytical model of rolling force for TiAl alloy pack rolling

Influence of Inner Roller Geometric Parameters on Counter-Roller Spinning with 6061 Aluminum Alloy Tube

Formation of concavities on the ends of parts manufactured on CNC skew rolling mills

Calculation and analysis of rolling force during aluminum alloy thick plate snake/gradient temperature rolling with different roll diameters

An Efficient Multi-Scale Modeling Method that Reveals Coupled Effects Between Surface Roughness and Roll-Stack Deformation in Cold Sheet Rolling

Process design and finite element analysis of multi-station two-roller cassette hot rolling for aluminum alloy 6061 wire

Analytic Numerical Modeling for Thermal Mechanical Processing of Plate under Rolling

DEVELOPMENT OF THE TECHNOLOGICAL PROCESS OF ROLLING BARS IN THE NEW DESIGN RADIAL SHEAR MILL BY USING PHYSICAL MODELING