Abstract:Ultra-high-performance seawater sea-sand concrete (UHPSSC) has attracted increasing attentions over the past few years as it exhibits exceptional mechanical and durability properties similar to conventional ultra-high-performance concrete (UHPC). Comparing to conventional UHPC, UHPSSC has great advantages when applied in marine engineering, particularly in offshore projects where construction materials are not easily accessible, and the transportation is costly. Nonetheless, current production of UHPSSC still necessitates large amounts of cement due to its low water/binder ratio. The larger demands of cement in manufacturing UHPSSC/UHPC than ordinary concrete can lead to substantial increase in the carbon emission. Therefore, an eco-friendly UHPSSC is developed in this paper by incorporating a promising ternary binder system (LC3) that consists of limestone (LS), calcined clay (metakaolin) and cement. The influence of the metakaolin (MK) dosage on the mechanical, hydration and microstructure properties of UHPSSC is comprehensively studied by carrying out a variety of experiments including mechanical test, isothermal conduction calorimetry test, TGA, XRD, SEM etc. The results showed that the UHPSSC mixed with LC3 exhibited lower early-age compressive strength than the reference mix, but its long-term strength was better than the reference group owing to the formation of more hydrates at the late age by the pozzolanic reaction of MK and the synergistic reaction between LS, MK and cement. Based on this study, the coupled replacement rate of cement by LS and MK could reach up to 40% without strength compromise. Nonetheless, 20% MK and 10% LS appeared to be the optimum substitution rate (total substitution rate of 30%) where the highest long-term strength was achieved. The main exothermic peak and total heat of hydration normalized per binder weight decreased with the increase of MK content level, but the main peak occurred earlier. Moreover, the addition of seawater can promote the hydration, leading to a greater main exothermic peak.

Feasibility Study on the Preparation of Ternary Cement with Calcined Slag Powder and Seashell Powder As Supplementary Cementitious Materials

Mechanical and Durability Properties of Sustainable Self-Compacting Concrete with Recycled Concrete Aggregate and Fly Ash, Slag and Silica Fume

Development of Sustainable Self-Compacting Concrete Using Recycled Concrete Aggregate and Fly Ash, Slag, Silica Fume

Sustainable Utilization of Waste Oyster Shell Powders with Different Fineness Levels in a Ternary Supplementary Cementitious Material System

Sustainable Use of Waste Oyster Shell Powders in a Ternary Supplementary Cementitious Material System for Green Concrete

Efficient Utilization of Waste Marine Clay for Fine Aggregate to Develop Sustainable and Cost-Effective Strain-Hardening Cement-Based Composites

Mechanical properties and hydration of ultra-high-performance seawater sea-sand concrete (UHPSSC) with limestone calcined clay cement (LC3)

Optimization of synergy between cement, slag, and phosphogypsum for marine soft clay solidification

Effect of calcined clays from Victoria, Australia as cement substitution in ternary blended cement systems

Effect of steel slag powder and stone powder by-product from manufactured sand on the mechanical properties and microstructure of cementitious materials

The Synergistic Effect of Calcained Coal-Series Kaolinite and Limestone on the Hydration of Portland Cement

Preparation of activated electrolytic manganese residue-slag-cement ternary blended cementitious material: Hydration characteristics and carbon reduction potential

Mechanical Performance of Portland Cement, Coarse Silica Fume, and Limestone (PC-SF-LS) Ternary Portland Cements

Compressive strength and environmental impact of sustainable blended cement with high-dosage Limestone and Calcined Clay (LC2)

Calcined nanosized tubular halloysite for the preparation of limestone calcined clay cement (LC 3 )

Synergistic effect of recycling waste coconut shell ash, metakaolin, and calcined clay as supplementary cementitious material on hardened properties and embodied carbon of high strength concrete

Influence of C–S–H seed and sodium sulfate on the hydration and strength of limestone calcined clay cement

Study on the Influence of Thermoplastic Microcapsules on the Sulfate Resistance and Self-Healing Performance of Limestone Calcined Clay Cement Concrete

Limestone Calcined Clay as Potential Supplementary Cementitious Material—An Experimental Study

Effects of w/b ratio, fly ash, limestone calcined clay, seawater and sea-sand on workability, mechanical properties, drying shrinkage behavior and micro-structural characteristics of concrete

Resource utilization of solid waste from steel industries in cement-based cementitious materials: Mechanical properties, hydration behaviors, and environmental impact