Abstract:Abstract In this paper, we propose a thermal wind speed sensor Verilog-A model with thermal-fluid-electric hybrid characteristics. Because the structure of the thermal wind sensor and the interface circuit chip are designed separately, which cannot effectively carry out MEMS-IC (integrated circuit) co-simulation, the overall performance of the sensor and interface circuit chip is prone to large deviation. At the same time, the separation of MEMS structure and IC design process leads to long product development cycle and high cost. This paper proposes an improved simulation model by analyzing the behavior characteristics of the thermal wind speed sensor. The simulation model consists of 11 thermistors, 3 capacitors, a voltage-controlled voltage source, and a voltage-controlled current source. The Taylor series expansion of the differential equation of heat conduction is carried out, and then the thermistor and capacitor networks are established according to the corresponding relationship between the thermal parameters and the electrical parameters, including the thermal conduction unit, the convection unit and the heat capacity in the chip. The model fully considers the effects of various physical effects and parasitic effects, and is implemented using the hardware description language Verilog-A. The sensor and interface circuit can be simulated simultaneously to optimize the circuit design. It is beneficial to the integration of sensors and interface circuit, reducing the number of tape-outs, increasing the success rate, and reducing costs. The consistency between the simulation results and the experimental curves verified the correctness of the macro model. The behavior characteristics of constant power (CP) and constant temperature heating were described. In CP mode, the output voltage error is less than ± 6.5%, the chip temperature error is less than 4.0%. The presented modeling approach can be the basis for the development of complete MEMS-IC design technology library of thermal wind speed sensor, aiming at optimum designs of integrated thermal wind speed sensor.

Modeling of an uncooled CMOS THz thermal detector with frequency-selective loop antenna and NMOS temperature sensor

Modeling of an uncooled CMOS THz thermal detector with frequency‐selective cross‐dipole antenna and NMOS temperature sensor

Modeling of an Uncooled CMOS THz Thermal Detector With Frequency-Selective Dipole Antenna and PTAT Temperature Sensor

Design and Measurement of CMOS Terahertz Thermal Detector with Gate-antenna and NMOS Transistors

Monolithic resonant CMOS fully integrated triple-band THz thermal detector

Polysilicon Terahertz Thermal Detector Based on CMOS Technology

Design of CMOS Temperature Detection Circuit

A Cavity-Coupled Microbolometer Terahertz Detector with a Metamaterial Reflector

Modeling of antenna-coupled Si MOSFETs in the Terahertz Frequency Range

A Terahertz Optomechanical Detector Based on Metasurface and Bi-Material Micro-Cantilevers

Terahertz Detectors Using Microelectromechanical System Resonators

Design and thermodynamic analysis on capacitive uncooled IR detector

Wireless Passive Microwave Antenna-Integrated Temperature Sensor Based on CSRR

Investigation of antenna-coupled Nb5N6 microbolometer THz detector with substrate resonant cavity

A Novel Terahertz Detector Based on Asymmetrical FET Array in 55-nm Standard CMOS Process

A terahertz detector operating at room temperature

Design of Arbitrarily Polarized CMOS Terahertz Detector Based on Plasmonic Antenna

Nanoantenna Integrated Thermomechanical Infrared Detector

Dual-frequency CMOS Terahertz Detector with Silicon-Based Plasmonic Antenna

An efficient macro model for CMOS-MEMS thermal wind speed sensor

Hemispherical lens integrated room temperature ultra-broadband GaAs HEMT terahertz detector