Abstract:The influence of temperature changes on infrared optical system structure parameters was analyzed.The defo-cusing distance and modulation transfer function (MTF)caused by temperature shift were calculated.The theoretical ba-sis of athermal design for infrared optical system was given.Based on a factual long-wave infrared optical system,the im-aging qualities at the working temperature of 20 ℃,-40 ℃and 60 ℃were analyzed by ZEMAX.The analytic results show that the image quality of the system approaches the diffraction limit at the working temperature of 20℃.The MTF is greater than 0.6 in the whole field of view when the Nyquist frequency of detector is 20 lp/mm,and 87.6%of the dif-fraction energy is focused in a single pixel,and the imaging quality of the system is good.However,the imaging quality decreases seriously at the working temperature of-40 ℃ to 60 ℃,so the system can’t satisfy the design require-ment.Based on the above analysis,the infrared optical system was redesigned by optical passive athermal with hybrid re-fractive/diffractive.The imaging quality of this infrared optical system is greatly improved after athermal design.The MTF is greater than 0.55 in the whole field of view when the Nyquist frequency of detector is 20 lp/mm,and the energy distribution is very concentrated,which can meet the requirements of infrared detection system.

Design and thermodynamic analysis on capacitive uncooled IR detector

Temperature-dependence improvement for a MEMS gyroscope using triangular-electrode based capacitive detection method

Uncooled Infrared Detection Using CMOS Thermomechanical Capacitive Sensors

Influence of temperature on infrared optical system and athermal design

Structure design and test of MEMS thermocouple infrared detector

Performance Enhance of CMOS-MEMS Thermoelectric Infrared Sensor by Using Sensing Material and Structure Design

A Uncooled A-Si Infrared Detector with Novel Thermal Isolation Method.

Design of Capacitive-Read Infrared FPA

Novel Micromachined Uncooled Infrared Detector Employing A-Si:H TFT As Thermosensitive Element

Novel Absorber Membrane and Thermocouple Designs for CMOS-MEMS Thermoelectric Infrared Sensor

Design and fabrication of uncooled MEMS capacitive FPA for IR imaging

Design and analyse on catadioptric MWIR athermal imaging system

Study on a High Performance MEMS Infrared Thermopile Detector

The Design of a 2×2 Polymer TIR Switch Based on Thermal Field Analysis Employing Thermo-Optic Effect

Novel Terraced Cavities Design on IR-Absorber Surface for CMOS-MEMS Thermoelectric Infrared Sensor

Novel High Thermal Resistance Structure Design for Responsivity and Detectivity Enhancements of Cmos Mems Thermoelectric Infrared Sensor

Optimization Design of Uncooled Amorphous Silicon Thin Film Transistor Infrared Detector

Design, fabrication, and characterization of a high-performance CMOS-compatible thermopile infrared detector with self-test function

Thermal Behavior of Amorphous Silicon Thin Film Transistor and Its Application to Micromachined Uncooled Infrared Sensors

Design and Measurement of CMOS Terahertz Thermal Detector with Gate-antenna and NMOS Transistors

A Uncooled Α-Si Infrared Detector Using Polyimide As Thermal Isolation Layer