Abstract:Ultrafast fiber lasers combining high peak power and excellent beam quality in the 1-µm wavelength range have been explored to applications in industry, medicine and fundamental science. Here, we report generation of a high-energy sub 300 fs polarization maintaining fiber chirped pulse amplification (CPA) system by using a Yb-doped large mode area tapered polarization maintaining (PM) optical fiber with the core/cladding diameters of 35/250 µm at the thin end and 56/400 µm at the thick end. The taper fiber design features a confined core for selective gain amplification and multi-layer cladding for enhanced suppression of higher order modes. In this regime, we have demonstrated 266 fs pulse amplification with peak power of up to 132 MW at a repetition rate of 2 MHz and high beam quality with measured M2 value of 1.1∼1.3. To the best of our knowledge, it is the highest peak power reported in such tapered Yb-doped fiber (T-YDF) amplifier in the femtosecond regime. This work indicates the great potential of the T-YDF to realize further power scaling, high laser efficiency, and excellent beam quality in high-power femtosecond fiber lasers.

450 W pulsed laser system with M<SUP>2</SUP> < 1.2 based on a 969-nm laser diode end-pumped Yb:YAG rod amplifier

Fiber-solid, Hybrid, Single-Frequency Laser (100 W) with a 100 MHz Repetition Rate and 1 Ns Pulse Width from a Spherical Aberration Compensated Four-Stage Nd:YVO4 Amplifier

An efficient high-power femtosecond laser based on periodic-layered-Kerr media nonlinear compression and a Yb:YAG regenerative amplifier

High Peak Power and High Beam Quality Fiber-Solid Hybrid Amplification Laser System

Compact, High-Power, High-Beam-quality Quasi-Cw Microsecond Five-Pass Zigzag Slab 1319 Nm Amplifier

Thin-disk multi-pass amplifier for kilowatt-class ultrafast lasers

Low repetition rate broadband high energy and peak power nanosecond pulsed Yb-doped fiber amplifier

Picosecond Yb-doped tapered fiber laser system with 1.26 MW peak power and 200 W average output power

100 MW Peak Power Picosecond Laser Based on Hybrid End-Pumped Nd:YVO4 and Side-Pumped Nd:YAG Amplifiers

885 Nm LD End-Pumped 22.7 W High Beam Quality Electro-Optical Q-switched Nd:YAG Laser

Femtosecond Yb-doped Tapered Fiber Pulse Amplifiers with Peak Power of over Hundred Megawatts

Yb-Doped Fiber Chirped Pulse Amplification System Delivering 1 mJ, 231 fs at 1 kHz Repetition Rate

95-Ps All-Solid-state Laser with a Low-Power Microchip Laser Seed and a Two-Stage Single-Pass Bounce Geometry Amplifier

8.2 Kw High Beam Quality Quasi-Continuous-Wave Face-Pumped Nd:Yag Slab Amplifier

High Peak Power Picosecond Hybrid Fiber and Solid-State Amplifier System

A 4.8-kW high-efficiency 1050-nm monolithic fiber laser amplifier employing a pump-sharing structure

All-fiber 30-μm core diameter Yb-doped pulse-pumped amplifier cascade generating 10 nm-bandwidth 545 kW peak power pulses

Compact Multipass Nd:YVO_4 Slab Laser Amplifier Based on a Hybrid Resonator

1 Mj, 500 Khz Nd:YAG/Nd:YVO4 MOPA Laser with a Nd:YAG Cavity-Dumping Seed Laser

All-Fiber Millijoule Energy and Nanoseconds Pulse Operation of A High Beam Quality Multi-Stage Pulse-Pumped Yb-Doped Amplifier Cascade

Linearly-polarized single-transverse-mode high-energy multi-ten nanosecond fiber amplifier with 50W average power.

450 W pulsed laser system with M<SUP>2</SUP> &lt; 1.2 based on a 969-nm laser diode end-pumped Yb:YAG rod amplifier