Abstract:Recently tetrapod piled jacket (TPJ) foundations are considered as a promising solution for offshore wind turbines in waters with depths ranging from 20 m to 50 m. This paper presents a numerical study into the monotonic lateral loading behaviour of TPJ foundations in medium sand, in terms of overall load-displacement responses of TPJ foundations and internal force within individual corner piles as well as pile-soil interaction. The results of previous centrifuge model tests are used to provide high-quality verification for the development of a 3D finite element model established by ABAQUS. A series of parametric studies is then carried out to look into more detailed response of TPJ foundations subjected to lateral loads, including the influence of spacing and slenderness ratio of piles, loading height as well as soil friction angle. The numerical results show that there are two various deformation models of TPJ foundations during lateral loading. One is shearing dominated deformation model under smaller loads, while another one is overturning dominated model under larger loads. Moreover, the lateral soil-pile interaction is found to be greatly influenced by enhancing/weakening effects of the axial forces of individual piles. The cause of this phenomenon is primarily due to the change in soil stress induced by pile vertical movement and radial deformation. To quantify this effect on pile-soil interaction of TPJ foundation, an enhancement factor Gamma(s), defined as the ratio of the soil resistance on downwind piles to that on upwind piles, is proposed. Consequently, the relationship between Gamma(s), depth of influence zone z(c )and four parameters are carefully investigated. For simplicity, the Gamma(s) is assumed constant and independent with pile lateral deflection as well as soil depths, based on which the values for Gamma(s) and z(c) are recommended for practical design uses. It is highlighted in the present study that these values should be chosen based on the specific loading conditions to provide much safer and more robust design for TPJ foundations.

SPT-based Empirical Method for Estimating Axial Capacities of Single-Helix Piles in Sand

A New and Openly Accessible Database of Tests on Piles Driven in Sands

Design Method Reliability Assessment from an Extended Database of Axial Load Tests on Piles Driven in Sand

Database Assessment of Design Methods for Axial Bearing Capacity of Driven Piles in Sand

DEM Study of the Stress Fields Around the Closed-Ended Displacement Pile Driven in Sand

Large-Deformation Finite-Element Simulation of Deformation and Strain Fields Resulting from Closed-End Displacement Pile Installation in Sand

Three-Dimensional DEM Simulation of Plugging Behaviour of Small-Diameter Open-Ended Model Piles Penetrating Into Sand

Assessment of design methods for axial bearing capacity of driven piles in clay

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Performance of laterally loaded H-piles in sand

Field and Model Investigations into the Influence of Age on Axial Capacity of Displacement Piles in Silica Sands

Field Tests and Simplified Calculation Method for Static Drill Rooted Nodular Pile

Influence of the Penetration of Adjacent X-section Cast-in-place Concrete (XCC) Pile on the Existing XCC Pile in Sand

Field Behavior of Driven Prestressed High-Strength Concrete Piles in Sandy Soils

Experimental Study on the Development of Surrounding Soil Stress During XCC Pile Installation in Sand

Assessment of Direct Cpt and Cptu Methods for Predicting the Ultimate Bearing Capacity of Single Piles

Ultimate Soil Resistance of the Laterally Loaded Pile in Uniform Sand

Numerical Investigation on the Lateral Loading Behaviour of Tetrapod Piled Jacket Foundations in Medium Dense Sand

Effect of Spatial Correlation of Standard Penetration Test (spt) Data on Bearing Capacity of Driven Piles in Sand

Predicting the vertical bearing capacity of single piles based on SCPTU test

A Simplified Analytical Method of Lateral Bearing Capacity of Rigid Single Pile Considering All Soil Reactions in Sand