Abstract:Aluminum nitride (AlN)-on-Si MEMS resonators operating in Lamb wave modes have found wide applications for physical sensing and frequency generation. Due to the inherent layered structure, the strain distributions of Lamb wave modes become distorted in certain cases, which could benefit its potential application for surface physical sensing. This paper investigates the strain distributions of fundamental and first-order Lamb wave modes (i.e. S0, A0, S1, A1 modes) associated with their piezoelectric transductions in a group of AlN-on-Si resonators. The devices were designed with notable change in normalized wavenumber resulting in resonant frequencies ranging from 50 to 500 MHz. It is shown that the strain distributions of four Lamb wave modes vary quite differently as normalized wavenumber changes. In particular, it is found that the strain energy of A1-mode resonator tends to concentrate to the top surface of acoustic cavity as the normalized wavenumber increases, while that of S0-mode device becomes more confined in the central area. By electrically characterizing the designed devices in four Lamb wave modes, the effects of vibration mode distortion on resonant frequency and piezoelectric transduction were analyzed and compared. It is shown that designing A1-mode AlN-on-Si resonator with identical acoustic wavelength and device thickness benefits its surface strain concentration as well as piezoelectric transduction, which are both demanded for surface physical sensing. We herein demonstrate a 500-MHz A1-mode AlN-on-Si resonator with decent unloaded quality factor (Qu = 1500) and low motional resistance (Rm = 33 Ω) at atmospheric pressure.

Microfabricated Aluminum Nitride MEMS Resonator.

High speed surface acoustic wave and laterally excited bulk wave resonator based on single-crystal non-polar AlN film

A Resonant Z-Axis Aluminum Nitride Thin-Film Piezoelectric MEMS Accelerometer

Ultra High Q Lithium Niobate Resonator at 15-Degree Three-Dimensional Euler Angle

Investigation on Quasi Lamb Wave Modes in AlN-on-Si MEMS Resonators

High Quality Silicon-Based Aln Thin Films For Mems Application

Microfabrication of piezoelectric MEMS based on thick LiNbO3 single-crystal films

Fabrication of Silicon Nitride Membrane Nanoelectromechanical Resonator

AlN micromechanical radial-contour disc resonator

Design, Modeling and Characterization of High-Performance Bulk-Mode Piezoelectric MEMS Resonators

A Lame Mode Resonator Based on Aluminum Nitride on Silicon Platform

Miniaturized Multi-Cantilever MEMS Resonators with Low Motional Impedance

Wafer-Level Vacuum-Packaged High-Performance AlN-on-SOI Piezoelectric Resonator for Sub-100-MHz Oscillator Applications

High-Band AlN Based RF-MEMS Resonator for TSV Integration

Lateral Extensional Mode Piezoelectric ZnO-on-Nickel RF MEMS Resonators for Back-End-of-Line Integration

High Sensitivity Piezoelectric MEMS Microphones Based on AlN with Cavity-SOI

A Novel Micromechanical Resonator Using Two-Dimensional Phononic Crystal Slab

Micromechanical Resonators Based on Silicon Two-Dimensional Phononic Crystals of Square Lattice

Niobate-on-Niobate Resonators with Aluminum Electrodes

Fabrication and Characterization of AlN-based, CMOS compatible Piezo-MEMS Devices

Characterization of Nanomechanical and Piezoelectric Properties of Aln Thin Film for Thin Film Bulk Acoustic Wave Resonators