Abstract:Aluminum nitride (AlN)-on-Si MEMS resonators operating in Lamb wave modes have found wide applications for physical sensing and frequency generation. Due to the inherent layered structure, the strain distributions of Lamb wave modes become distorted in certain cases, which could benefit its potential application for surface physical sensing. This paper investigates the strain distributions of fundamental and first-order Lamb wave modes (i.e. S0, A0, S1, A1 modes) associated with their piezoelectric transductions in a group of AlN-on-Si resonators. The devices were designed with notable change in normalized wavenumber resulting in resonant frequencies ranging from 50 to 500 MHz. It is shown that the strain distributions of four Lamb wave modes vary quite differently as normalized wavenumber changes. In particular, it is found that the strain energy of A1-mode resonator tends to concentrate to the top surface of acoustic cavity as the normalized wavenumber increases, while that of S0-mode device becomes more confined in the central area. By electrically characterizing the designed devices in four Lamb wave modes, the effects of vibration mode distortion on resonant frequency and piezoelectric transduction were analyzed and compared. It is shown that designing A1-mode AlN-on-Si resonator with identical acoustic wavelength and device thickness benefits its surface strain concentration as well as piezoelectric transduction, which are both demanded for surface physical sensing. We herein demonstrate a 500-MHz A1-mode AlN-on-Si resonator with decent unloaded quality factor (Qu = 1500) and low motional resistance (Rm = 33 Ω) at atmospheric pressure.

Design, Modeling and Characterization of High-Performance Bulk-Mode Piezoelectric MEMS Resonators

A Piezoelectric Width-Flexural Mode MEMS Resonator with High Quality Factor and Low Motional Resistance

A Novel Piezoresistive Transducer for Bulk Mode MEMS Resonator

A Temperature-Stable and Low Impedance Piezoelectric MEMS Resonator for Drop-in Replacement of Quartz Crystals

Design for High-Quality Factor of Piezoelectric-on-silicon MEMS Resonators Using Resonant Plate Shape and Phononic Crystals

JMEMS Letters.1pt A Q-factor Boost Strategy for High-Order Width-Extensional Mode MEMS Resonators by Varied Unit Length

Quality Factor Improvement of Piezoelectric MEMS Resonator by the Conjunction of Frame Structure and Phononic Crystals

High speed surface acoustic wave and laterally excited bulk wave resonator based on single-crystal non-polar AlN film

Quality Factor Enhancement of Piezoelectric MEMS Resonator Using a Small Cross-Section Connection Phononic Crystal

Investigation on Quasi Lamb Wave Modes in AlN-on-Si MEMS Resonators

Multi-Stage Frames for Q-Enhancement in Piezoelectric MEMS Resonators

A GHz Silicon-Based Width Extensional Mode MEMS Resonator with Q over 10,000

A High-Performance Bulk Mode Single Crystal Silicon Microresonator Based On A Cavity-Soi Wafer

A high Q micromachined single crystal silicon bulk mode resonator with pre-etched cavity

Triple-order Optimization for Performance Enhancement of Piezoelectric MEMS Resonator

Q-enhancement of Piezoelectric Micro-Oven Controlled MEMS Resonators Using Honeycomb Lattice Phononic Crystals

A Winding-Frame-Structure Thin-Film MEMS Resonator for Quality Factor Improvement

A Micro-Oven-Controlled Dual-Mode Piezoelectric MEMS Resonator with ±400 PPB Stability over −40 to 80 °C Temperature Range

Ultra High Q Lithium Niobate Resonator at 15-Degree Three-Dimensional Euler Angle

Lateral Extensional Mode Piezoelectric ZnO-on-Nickel RF MEMS Resonators for Back-End-of-Line Integration

A Piezoelectric Mechanically Coupled Lamé Mode Resonator with Ultra-High Q