Abstract:Miniaturization of piezoelectric devices such as ultrasonic motors, transformers, and sound projectors requires high power density maintained in the piezoelectric materials. During operation, heat generation due to material losses, however, hinders the realization of high power density. As a result, it is very important to understand the loss mechanisms in piezoelectric materials to successfully realize device miniaturization and at the same time maintain a good device performance. There are three fundamental losses in piezoelectric materials: dielectric, elastic, and piezoelectric. The first two components have been intensively investigated, whereas piezoelectric loss has not received much attention, which leaves some phenomena inexplicable. To verify its significance, in this paper, a new methodology has been presented to calculate the dielectric, elastic and piezoelectric losses based on a new equivalent circuit (EC) deduced from the revised Hamilton’s Principle. The improvement of the new methodology lies in the fact that all the three losses, including the piezoelectric loss, have been fully taken in consideration. The derivations and the calculation results indicate that the piezoelectric loss is not only non-negligible, but is also larger than other two components for hard PZT materials. The significance of the piezoelectric loss component has been therefore verified. During the above verification process, an elegant and concise measuring procedure of all the losses, including piezoelectric component, has been presented from an EC aspect for the first time. The calculation and measurement also indicate that the largest mechanical quality factor exists at a frequency between resonance and antiresonance, which may suggest a new optimal working frequency for piezoelectric devices from the loss reduction viewpoint.

Characterization of Acoustic Losses in Interdigitated VHF to mmWave Piezoelectric M/NEMS Resonators

Phononic loss in superconducting resonators on piezoelectric substrates

Analysis of Longitudinal and Torsional Resonance Vibrations of a Piezoelectrically Excited Bar by Introducing Piezoelectric Loss Coefficients

Acoustic and Electromagnetic Co-Modeling of Piezoelectric Devices at Millimeter Wave

Suspended Frame Structure with Phononic Crystals for Anchor Loss Reduction of MEMS Resonator

Support Losses in Micromechanical Resonators Under Electrostatic and Piezoelectric Actuations

Multi-stage Phononic Crystal Structure for Anchor-Loss Reduction of Thin-Film Piezoelectric-on-silicon Microelectromechanical-System Resonator

Synchronized Opto-Electro-Mechanical Measurements for Energy Loss Estimation in Thin-Film-Piezoelectric-on-Substrate MEMS/NEMS Devices

The mechanism of loss in the impedance spectrum of longitudinal piezoelectric oscillator

Three-Dimensional Finite Element Analysis and Characterization of Quasi-Surface Acoustic Wave Resonators

Dominant Loss Mechanisms of Whispering Gallery Mode RF-MEMS Resonators with Wide Frequency Coverage

Dissipation Analysis Methods and Q-Enhancement Strategies in Piezoelectric MEMS Laterally Vibrating Resonators: A Review

Losses in Piezoelectrics Derived from a New Equivalent Circuit

2-16 GHz Multifrequency X-Cut Lithium Niobate NEMS Resonators on a Single Chip

Localized Topological States beyond Fano Resonances via Counter-Propagating Wave Mode Conversion in Piezoelectric Microelectromechanical Devices

Fundamental Antisymmetric Mode Acoustic Resonator in Periodically Poled Piezoelectric Film Lithium Niobate

Quality Factor Enhancement of Piezoelectric MEMS Resonator Using a Small Cross-Section Connection Phononic Crystal

Design for High-Quality Factor of Piezoelectric-on-silicon MEMS Resonators Using Resonant Plate Shape and Phononic Crystals

Quality Factor Improvement of Piezoelectric MEMS Resonator by the Conjunction of Frame Structure and Phononic Crystals

Electromechanical Equivalent Circuit Model of a Piezoelectric Disk Considering Three Internal Losses