Abstract:During tunnelling, with the progression of the shield tunnelling machine, the shield tail brush, which is an important accessory required to seal the shield tail and prevent the tunnel from ground water or grouting fluid discharging, will gradually be worn-out/damaged and inevitably lead to safety problems. As a result, problematic tail brush needs to be replaced to prevent more serious problems from happening before any further tunnelling. The replacement of this shield tail brush can be very risky, especially when the shield tunnelling machine is located at a soil layer under high pore-water pressure. This study introduces an engineering practice to facilitate the shield tail brush replacement under high pore-water pressure through the development of a frozen soil wall with the help of an artificial freezing technique using liquid nitrogen. A case study is adopted to demonstrate the implementation of this technique. For the specific site condition, a numerical simulation is usually performed first to determine the design parameters (e.g., liquid nitrogen temperature, length and spacing of the freezing pipes) required for artificial freezing process. Several holes along the radial direction of the tunnel were then made to monitor the temperature of the soil around the tunnel. Subsequently, the artificial freezing process was performed according to the design. The replacement of the tail brush was initiated when the frozen soil wall developed during freezing met the requirements for tail brush replacement. The artificial freezing technique using liquid nitrogen proved to be a reliable and time-effective option to facilitate the tail brush replacement under high pore-water pressure.

The Fire Work Technology of Soil Blockingand Vapour Replacing for Pipe

One technique for shield tail brushes' repair using liquid nitrogen freezing method in the artesian aquifer

STUDY ON ELIMINATING FIRE-CARRYING IN PRIMARY AIR JET ORIFICE BY ADMIXING EXHAUST GAS

Numerical Analysis and Comparison of Soil Freezing Schemes for Replacement of Shield Tail Brush in Long-Distance Tunnel Engineering

Application of Multi-Tangential Firing Technology to Settling the High Temperature Corrosion of Water Wall Tube of Boiler

Practical analysis of cleaning water supply pipeline using air and water flushing technology

Applicability Analysis of Thermoplastic Material As Liner Pipe for Trenchless Rehabilitation of Thermal Pipelines

The Application of Non-Excavation Pipeline Rehabilitation Technology in Power Plants Water Pipelines

In‐Pipe Maintenance Robot Using Spray‐In‐Place Pipe Technique for Long‐Distance and Complex Pipe Environment

FRACTURE ANALYSIS OF THE PIPES FOR EXCHANGING BOILER'S SURPLUS HEAT

A Kind of Gas Drainage Pipeline Pressure Relief Explosion Blocking Device

Environmental treatment technology for complex coalfield fire zone in a close distance coal seam—A case study

Discussion On The Application Of Heat Pipes In Coalfield Fires Prevention

Experimental and numerical simulation of formed-in-place pipe liner for repairing water mains with void

Technology of Double Pipe and Non-Shrinkage Double Liquid Grouting WSS of Beijing Subway Line 10

The Studying of Online Leak Sealing Technology with Fluid Diversion and Welding on Gas Pipeline

Improvement of the Tightness Technique for New Type Steam Soot Blower

Pipe Blockage Mechanism Study on Dense Phase & Positive Pressure Gas Ash Conveying System & Its Treatment

An Artificial Freezing Technique to Facilitate Shield Tail Brush Replacement under High Pore-Water Pressure Using Liquid Nitrogen

Grouting sealing method of flow-control speed-down in karst pipelines and its engineering application

Research on Environmentally Safe Flame Retardant Technology of Asphalt Concrete Pavement in Long Tunnel