Abstract:This paper presents on-line qualification of the effective diameter of the micro-stylus tip ball of a micro probing system for precision length measurement of micro-features on precision parts by utilizing a set of gauge blocks as the qualification artefact, which is composed by one calibrated gauge block and two supporting gauge blocks that are wrung together for a good mechanical stability. The qualification artefact is aligned side by side with the precision part to be measured for enabling a rapid transfer between the qualification step of the probe two-point tip ball diameter and the length measurement step of the precision part. Based on the proposed setup, on-line qualifications of a micro-stylus with a nominal tip ball diameter of 52.6 μm were carried out by using two methods referred to as Method A and Method B, respectively. Method A is operated by probing the opposite sides of the gap between the two supporting gauge blocks separated by the calibrated gauge block, and Method B is operated by probing the opposite sides of the calibrated gauge block supported by the two supporting gauge blocks. Intensive uncertainty analyses based on the experimental results and the geometrical models were carried out to compare the performances of these two methods. Method A, which was confirmed to be more accurate and faster than Method B, was then employed to measure the width of a micro-gap on a precision part with compensation of the determined effective two-point tip ball diameter.

Design of Intellectualized 2-D Horizontal Probe

Three-Dimensional Measurement System for Inner Surface of Long Tubular Parts Based on White Light Interference

Design and Testing of a Micro-thermal Sensor Probe for Nondestructive Detection of Defects on a Flat Surface

An Improved Two-Point Real-Time Measuring Method for Radial Micro-Displacement Measurement on High-Speed Smart Boring Bar

Precision Measurement of Z -Slide Vertical Error Motion of an Ultra-Precision Lathe by Using Three-Probe Method

Probe’s Auto-alignment in Curved Components Ultrasonic Survey

Development of Non - contact Measurement System Based on the Integration of Laser Probe and NC Machine Tools

On-line Qualification of a Micro Probing System for Precision Length Measurement of Micro-Features on Precision Parts

Design and Fabrication of a Silicon Probe for Surface Profilers

A Miniature Electric Probe with a High Spatial Resolution

Dynamic Confocal Optical Probe Based on Time Difference Measurement

Development of a High-Precision Multifunctional Probe for Measuring Microstructures

A Wideband and High Sensitivity Probe Design for Near-Field Scanning

Embedded displacement measuring device based on error separating technique of multi-circle overlapping three-probe method

Design and fabrication of a novel silicon probe for micromachined surface profilers

Full Area Covered 3D Profile Measurement of Special-Shaped Optics Based on a New Prototype Non-Contact Profiler.

A dual-probe three-dimensional profile measurement system

The Research and Design of Embedded New Type of Thrombelastograph Coagulation Analyzer System

Development of a Six-Degree-of-Freedom Analog 3D Tactile Probe Based on Non-Contact 2D Sensors

Design of a micro-displacement structure for 2-D precision positioning

Fabrication and testing of a novel silicon probe for micromachined surface profilers.