EFFECT OF SLIDING VELOCITY ON THE FRICTIONAL BEHAVIORS OF IN SITU GRANULAR EUTECTICS REINFORCED AUSTENITE STEEL MATRIX COMPOSITES

Jianguo Li

2003-01-01

Abstract:The effect of sliding velocity on the friction behaviors of in situ granular 7+(Fe, Mn)3C eutectics reinforced austenite steel matrix composites (EAMC) has been investigated by the pin-on disc dry sliding tests and scanning electron microscopy (SEM) observation. Results show that the frictional coefficient of the frictional system of EAMC against steel G45 decreases with the increment of sliding velocity, and the wear rate of EAMC increases with it. However, the wear rate of EAMC is much lower than that of austenite medium Mn steel (a single austenite phase), and the difference between the wear rates of EAMC and austenite medium Mn steel increases with the increment of sliding velocity. The dominant wear mechanisms of EAMC are abrasive wear and delamination wear at lower normal load, and oxidative wear and delamination wear at higher normal load by the observation of worn track and wear debris. Adhesion between EAMC and G45 is enhanced with the increment of the sliding velocity, so the amount of debris on the worn track increases with it. The mechanisms of influences of the sliding velocity on the frictional behavior are analyzed with the critical transition temperature theory and Archard wear theory.