Abstract:Scintillation crystal design is a critical component in positron emission tomography system development, which impacts a number of performance parameters including energy resolution, time resolution and spatial resolution. Our work aims to develop a generalized simulation tool to model the light transport inside scintillation crystals with good accuracy, taking into account surface treatments, reflectors, temporal dependence of scintillation decay, and comprehensive experimental validations. The simulation has been validated against both direct analytical calculation and experimental measurements. In this work, the studies were performed for a lutetium–yttrium oxyorthosilicate crystal of 3×3×20 mm3 dimension coupled to a Hamamatsu silicon photomultiplier, with respect to light output, rise-time slope, energy resolution and time resolution. Four crystal surface treatment and reflector configurations were investigated: GroundMetal, GroundPaint, PolishMetal and PolishPaint. The experiments were performed to validate the Monte Carlo simulation results. The results indicate that the best time resolution (0.96±0.05 ns) and good energy resolution (10.6±0.4%) could be produced by using a polished surface with specular reflector, while the configuration of a polished surface with diffusive reflector produces the best energy resolution (10.2±0.9%). The results indicate that a polished surface with diffusive reflector achieves the best energy resolution (10.2±0.9%) for 511 keV high energy photons, and a polished surface with specular reflector achieves the best time resolution (0.96±0.05 ns) measured against a Hamamatsu fast photomultiplier tube. The ground surface treatment is not recommended for its inferior performance in terms of energy and time resolution. Possible explanations and future improvements to be made to the developed simulation tool are discussed.

Design Optimization of Plastic Scintillators with Wavelength-Shifting Fibers and Silicon Photomultiplier Readouts in the Top Veto Tracker of the JUNO-TAO Experiment

Design optimization of JUNO-TAO plastic scintillator with WLS-fiber and SiPM readout

Study in the Optical Performance of Plastic Scintillator with WLS Fiber

Performance of the plastic scintillator modules for the top veto tracker of the Taishan Antineutrino Observatory

Electronics design for a muon imaging system using triangular plastic scintillators with WLS fiber readouts

Position-sensitive plastic scintillator detector with WLS-fiber readout

Optimizing the light output of a plastic scintillator and SiPM based detector through optical characterization and simulation: A case study for POLAR-2

Design & Optimization of the HV divider for JUNO 20-inch PMT

Optimum performance investigation of LYSO crystal pixels: A comparison between GATE simulation and experimental data

Low power implementation of high frequency SiPM readout for Cherenkov and scintillation detectors in TOF-PET

Readout Electronics Design for a Cosmic Ray Muon Imaging System

Sensitized Triplet‐triplet Annihilation in Nanostructured Polymeric Scintillators Allows for Pulse Shape Discrimination

Optimization of Dual Mode Readout of Sensl SiPM for TOF PET Detectors

DOI- and TOF-capable PET Array Detector Using Double-Ended Light Readout and Stripline-Based Row and Column Electronic Readout

Optical simulation of a 9×9 LYSO block detector with PQS technology using GATE

TOF and DOI Capable SiPM-PET Detector Using Striplines That Provide Row and Column Based Measurements

Study of Light Transport Inside Scintillation Crystals for Pet Detectors

Improving the timing resolution of a time-of-flight and depth-of-interaction PET array detector

Exploring Scintillators and Cherenkov Radiators for MIP Timing Detectors

Optical Optimization for Anti-Coincidence Detectors of a Hard X-ray Modulation Telescope

Design and Performance Optimization of SiPM Array Multiplexing Readout Circuit