Abstract:Effective online monitoring of the spatial distribution of high-energy radiation is of significant importance in various fields such as medical imaging, high-energy physics, and homeland security. However, achieving radiation detectors with both high sensitivity and minimal disturbance is an enormous challenge. The present study introduces a solution to this bottleneck issue through the development of a full-inorganic scintillating fiber, successfully demonstrating its application in constructing a radiation monitoring device. The scintillating fiber, activated with Ce3+ and fabricated using the melt-in-tube approach, is lightweight with a density of 2.5 g cm-3 and exhibits efficient scintillating emission with a light yield of 4000 photons MeV-1. These characteristics enable the achievement of radiation detection with high sensitivity while keeping disturbance to the incident radiation beam at a minimum. Furthermore, 2D and 3D radiation beam monitors are constructed based on these scintillating fibers, facilitating spatial radiation monitoring. The findings demonstrate that full-inorganic scintillating fibers and devices offer a synergistic combination of high sensitivity and negligible disturbances. This progress not only introduces a novel full-inorganic fiber for radiation detection but also suggests promising applications in various nuclear fields where 3D radiation beam tracking is essential. Scintillating fibers are employed to online monitoring for the spatial distribution of high-energy radiation. The fabrication of full-inorganic scintillating fibers using the melt-in-tube strategy offers significant advantages, including high sensitivity and minimal disturbance to the incident radiation. The application of these scintillating fibers in the construction of 2D and 3D radiation monitors enables precise tracking of spatial radiation beam distribution. image

Development of scintillating fiber detector technology for high rate particle tracking

A 1 mm Scintillating Fibre Tracker Readout by a Multi-anode Photomultiplier

Plastic scintillator fiber detectors for heavy ion trajectory reconstruction for the Super-FRS at FAIR

Online Radiation Beam Tracking by Using Full‐Inorganic Scintillating Fibers

Demonstration of particle tracking with scintillating fibres read out by a SPAD array sensor and application as a neutrino active target

New fiber read-out design for the large area scintillator detectors: providing good amplitude and time resolutions

SciFi: A large Scintillating Fibre Tracker for LHCb

Silicon photomultiplier arrays - a novel photon detector for a high resolution tracker produced at FBK-irst, Italy

Beam test of a 12-layer scintillating-fiber charged-particle tracking system

Monte Carlo simulation of a very high resolution thermal neutron detector composed of glass scintillator microfibers

Experimental results using a hybrid silicon pixel detector for scintillating fibre readout and X-ray imaging

Monte Carlo study of the time resolution of scintillating fibre detectors

A prototype scintillating fibre beam profile monitor for Ion Therapy beams

Scintillator-SiPM Detector for Tracking and Energy Deposition Measurements

Full‐Inorganic Micro‐Fiber Probe for Real‐Time Radiation Monitoring

The design, construction and performance of the MICE scintillating fibre trackers

Status of detector development for the European XFEL

Development of nanocomposite scintillators for use in high-energy physics

Exploring Scintillators and Cherenkov Radiators for MIP Timing Detectors