Abstract:Advances in Mechanical Engineering, Volume 16, Issue 10, October 2024. High-speed rotating blade vibration monitoring is of great significance for the safe operation of turbomachinery. Blade Tip Timing (BTT) is considered a promising technology in the field of blade vibration monitoring. The BTT signal analysis has the following problem, the displacement offset was caused by speed variation which affected the accuracy of the blade vibration parameter identification. Owing to the under-sampled characteristics of the BTT signals and multiple sensor data are required to identify the parameters. The accurate extraction of blade vibration characteristics is challenging. Thus, a vibration analysis method is proposed based on Displacement Offset Decreased and Compressed Sensing (DOD-CS). Firstly, the BTT signal pairwise is subtracted to reduce the impact of the displacement offset, and based on the subtractive results, a basis function is constructed to rebuild the dictionary matrix of the compressed sensing method. Then, we solved the signal sparse representation equation and obtained the spectrum estimation result, that is, the structure vibration parameters. The analysis of simulation data shows that the parameter identification accuracy of the DOD-CS method is higher than that of the OMP-CS (Orthogonal Matching Pursuit and Compressed Sensing) method, and the identification errors of frequency and amplitude are within 1% and 5%, respectively. The experimental results confirm the feasibility of the proposed method in identifying vibration parameters. Compared with existing methods, the innovation of the proposed method is that it eliminates the influence of displacement offset on the accuracy of parameter identification. For under-sampled signals, only two sensor data information are needed to complete spectrum estimation and parameter identification.

Sparsity-based Compressed Covariance Sensing for Spectrum Reconstruction in Blade Tip Timing.

A New Method for Non-Uniform Under-Sampled Blade Tip Timing Signal Reconstruction

Coprime and Nested Samplings-Based Spectrum Reconstruction in Blade Tip Timing

Super-Resolution Power Spectrum Estimation for Blade Tip Timing Measurement

An Improved Complex Multi-Task Bayesian Compressive Sensing Approach for Compression and Reconstruction of SHM Data

Time Delay-Based Spectrum Reconstruction for Nonuniform and Sub-Nyquist Sampling in Blade Tip Timing

An improved cyclostationary approach based on compressive sensing

Sparse Reconstruction Method of Non-Uniform Sampling and its Application in Blade Tip Timing System

Sparse Representation Based Frequency Detection and Uncertainty Reduction in Blade Tip Timing Measurement for Multi-Mode Blade Vibration Monitoring

Improved Minimum Variance Distortionless Response Spectrum Method for Efficient and Robust Non-Uniform Undersampled Frequency Identification in Blade Tip Timing

Non-convex Sparse Regularization Via Convex Optimization for Blade Tip Timing

Optimization of Nonuniform Sensor Placement for Blade Tip Timing Based on Equiangular Tight Frame Theory

Blade tip timing signals parameters identification based on Displacement Offset Decreased and Compressed Sensing

Robust sparse representation model for blade tip timing

Forward-backward Spatial Smoothing for Snapshot Matrix Construction of Blade Tip Timing Signal

Adaptive Iterative Approach for Efficient Signal Processing of Blade Tip Timing

Parameter Identification Based on Iterative Signal Space in Blade Tip Timing

Single-probe Blade Tip Timing Based on Sparse Bayesian Learning

Bayesian Compressive Sensing for Approximately Sparse Signals and Application to Structural Health Monitoring Signals for Data Loss Recovery

Subspace Dimension Reduction for Faster Multiple Signal Classification in Blade Tip Timing.

Compressed Line Spectral Estimation Using Covariance: A Sparse Reconstruction Perspective