Abstract:Monitoring rotor blade vibrations is imperative in aero-engine testing and service. Blade tip timing (BTT), a promising technique for such monitoring, assesses the operational status of rotor blades through non-intrusive measurement of blade tip displacement. Traditional BTT technology relies on the Once-Per-Revolution (OPR) probe, which poses installation challenges and introduces measurement uncertainties in practical applications. This paper introduces a novel OPR-free approach, employing Adaptive Variable Reference Blades (AVRB) for non-intrusive measurement of rotor blade vibrations. The method assumes a stochastic mistuning of blades within the same stage, resulting in non-simultaneous resonance of blades at a given speed. In each revolution, the vibration level of individual blades is determined by assessing the deviation between the average speed of a blade, as measured by two adjacent BTT probes, and the average speed across the entire circumference. Consequently, a non-vibrating blade is adaptively identified and selected as the reference blade. The relative vibration levels among blades vary dynamically during different revolutions, influenced by mistuning features, leading to variability in the reference blades. These adaptive variable reference blades can then replace the OPR probe, aiding in the computation of vibration displacement and further parameter identification of blades. To validate the effectiveness of the proposed method, a five-degree-of-freedom numerical model is utilized for simulation. Additionally, experiments involving both a five-bladed disk and an eight-bladed disk are conducted to validate the proposed approach. Numerical simulations and two sets of test results demonstrate a fundamental agreement between the blade vibration displacement calculated using the proposed method and the outcomes obtained through the traditional BTT method with OPR. The relative error in the identified blade vibration frequency derived from the blade vibration displacement, as determined by both methods, does not exceed 1 %. Additionally, the relative error in the amplitude of the blade vibration displacement is within the range of 10 %.

Non-convex Sparse Regularization Via Convex Optimization for Blade Tip Timing

A New Method for Non-Uniform Under-Sampled Blade Tip Timing Signal Reconstruction

Accelerated Algorithm for BTT Identification Parameter with GMC Sparse Regularization

An Improved Key-Phase-Free Blade Tip-Timing Technique for Nonstationary Test Conditions and Its Application on Large-Scale Centrifugal Compressor Blades

Blade Dynamic Strain Non-Intrusive Measurement Using L1/2-norm Regularization and Transmissibility

Robust sparse representation model for blade tip timing

Min-Max Probe Placement and Extended Relaxation Estimation Method for Processing Blade Tip Timing Signals

Sparse Representation Based Frequency Detection and Uncertainty Reduction in Blade Tip Timing Measurement for Multi-Mode Blade Vibration Monitoring

Sparse Reconstruction Method of Non-Uniform Sampling and its Application in Blade Tip Timing System

Sparse reconstruction for blade tip timing signal using generalized minimax-concave penalty

A Novel OPR-free Method for Blade Tip Timing Based on Adaptive Variable Reference Blades

Sparsity-based Compressed Covariance Sensing for Spectrum Reconstruction in Blade Tip Timing.

Blade Tip Timing for Multi-Mode Identification Based on the Blade Vibration Velocity

Experimental Study on the Optimization of the Sensor Arrangement for Blade Tip Timing Measurement

Parameter Identification Based on Iterative Signal Space in Blade Tip Timing

Blade Tip Timing for Monitoring Crack Propagation of Rotor Blades Using Block-AOLS

Single-probe Blade Tip Timing Based on Sparse Bayesian Learning

Adaptive Iterative Approach for Efficient Signal Processing of Blade Tip Timing

The connection between digital-twin model and physical space for rotating blade: an atomic norm-based BTT undersampled signal reconstruction method

Dynamic Strain Reconstruction of Rotating Blades Based on Tip Timing and Response Transmissibility

PSD estimation and modal parameter identification for random vibrations with blade tip timing measurement