Abstract:In a circulating fluidized bed (CFB) boiler, loop seal is one of the most commonly used non-mechanical valves. When the solids are conveyed horizontally from the supply chamber to the recycle chamber through the horizontal section, the length of the horizontal section will cause much flow resistance, which not only influences the fan burden but also the pressure and mass balance between the furnace and the external loop. In this paper, a new structure loop seal with a slope passage connecting the supply and recycle chambers (named N-type) is described. The flow characteristic of quartz sand (Geldart-B particles) in the new loop seal was studied by comparison with the traditional loop seal (named U-type).The experimental data show that the passage design connecting the two chambers of a loop seal has an obvious effect on the gas solid flow not only in the loop seal, but also in other components in the whole loop. For the N-type loop seal, the minimum aeration rate required for the onset of solid flow is equal to the minimum fluidization velocity of the bed materials, much less than with the U-type loop seal. The solid recycling capability of the N-type loop seal is better than of U-type one at low aeration rate, but this status will be reversed at high aeration rate. A small amount of vertical aeration into the bottom of the standpipe can further improve the solid recycling capability of the N-type loop seal, by reducing the inter-particle friction and build up a higher pressure drop gradient in the standpipe. At the same time, less air bypassing upward into the cyclone through the standpipe is found for the N-type loop seal at high level of aeration rate, while, at the same condition the U-type suffers severe gas bypassing with a fluidized state in the standpipe. At last, the pressure drop of the new type loop seal is much less than the pressure drop of the traditional one with the same solid flow rate, which provides an advantage for reducing fan power and sustaining more solids in the boiler furnace. (C) 2014 Published by Elsevier B.V.

An Experimental Study on the Operation Properties of a Loop Seal

Experimental Study on the Performance of Loop-Seal in a Horizontal Circulating Fluidized Bed Boiler

Impact of Loop Seal Structure on Gas Solid Flow in A Cfb System

Experimental and Numerical Simulation on Sequential Three Phase Jet-Loop Reactor

Investigation on the Hydrodynamic Properties in the External Loop of Circulating Fluidized Bed with a Loop Seal

FLOW RESISTANCE THROUGH HORIZONTAL ORIFICE OF LOOP SEAL WITH SIDE AERATION AIR

Structure effect of industrial loop reactors on non-uniform flow characteristics

Regulating Characteristics of Loop Seal in a 65 T/h Oil Shale-Fired Circulating Fluidized Bed Boiler

Experimental research on solids oscillation circulation behavior in circulating fluidized bed

Experimental Research on the Unstable Performances of Parallel External Loops in the Circulating Fluidized Bed

Numerical Study on the Process of Chemical Looping Hydrogen Production with Multiple Circulating Fluidized Bed Reactors

Experimental and Numerical Investigation on the Dynamic Characteristics of a Lab-Scale Transcritical CO2 Loop

Experiment Study of Solids Circulating Rate's Effect on the Pressure Loop in Circulating Fluidized Bed

Experimental Study of Solid Distribution and Circulation Rate in CFB

Application of CPFD Method in the Simulation of a Circulating Fluidized Bed with a Loop Seal Part II—Investigation of Solids Circulation

Impact of Operating Conditions on the Performance of the External Loop in a CFB Reactor

Cold Investigation on the Performance of a J-valve for Circulating Fluidized Beds

Control of fluid-bed solids recycle device

THE FLOW CHARACTERISTICS OF SAWDUST PARTICULATE IN LOOP SEAL

Pressure Balance Theoretical Analysis of Circulation Loop on CFBB

Solids Circulation Rate Prediction in a Pressurized Loop-Seal