Abstract:In a circulating fluidized bed (CFB) boiler, loop seal is one of the most commonly used non-mechanical valves. When the solids are conveyed horizontally from the supply chamber to the recycle chamber through the horizontal section, the length of the horizontal section will cause much flow resistance, which not only influences the fan burden but also the pressure and mass balance between the furnace and the external loop. In this paper, a new structure loop seal with a slope passage connecting the supply and recycle chambers (named N-type) is described. The flow characteristic of quartz sand (Geldart-B particles) in the new loop seal was studied by comparison with the traditional loop seal (named U-type).The experimental data show that the passage design connecting the two chambers of a loop seal has an obvious effect on the gas solid flow not only in the loop seal, but also in other components in the whole loop. For the N-type loop seal, the minimum aeration rate required for the onset of solid flow is equal to the minimum fluidization velocity of the bed materials, much less than with the U-type loop seal. The solid recycling capability of the N-type loop seal is better than of U-type one at low aeration rate, but this status will be reversed at high aeration rate. A small amount of vertical aeration into the bottom of the standpipe can further improve the solid recycling capability of the N-type loop seal, by reducing the inter-particle friction and build up a higher pressure drop gradient in the standpipe. At the same time, less air bypassing upward into the cyclone through the standpipe is found for the N-type loop seal at high level of aeration rate, while, at the same condition the U-type suffers severe gas bypassing with a fluidized state in the standpipe. At last, the pressure drop of the new type loop seal is much less than the pressure drop of the traditional one with the same solid flow rate, which provides an advantage for reducing fan power and sustaining more solids in the boiler furnace. (C) 2014 Published by Elsevier B.V.

Solids Circulation Rate Prediction in a Pressurized Loop-Seal

Steady-state Simulation of Core-Annulus Flow in a Circulating Fluidized Bed (CFB) Riser

Experimental and Numerical Simulation on Sequential Three Phase Jet-Loop Reactor

Experiment Study of Solids Circulating Rate's Effect on the Pressure Loop in Circulating Fluidized Bed

An Experimental Study on the Operation Properties of a Loop Seal

Experimental research on solids oscillation circulation behavior in circulating fluidized bed

CFD Simulation and Hydrodynamics Characterization of Solids Oscillation Behavior in a Circulating Fluidized Bed with Sweeping Bend Return

Application of CPFD Method in the Simulation of a Circulating Fluidized Bed with a Loop Seal Part II—Investigation of Solids Circulation

Numerical Simulations of Flow Structure and Heat Transfer in a Central Jet Bubbling Fluidized Bed

Pressure Balance Theoretical Analysis of Circulation Loop on CFBB

Dynamic Characteristics of Solids Circulation Establishment in Laboratory and Industrial Circulating Fluidized Beds with Sweeping Bend Return

Investigation on the Hydrodynamic Properties in the External Loop of Circulating Fluidized Bed with a Loop Seal

Investigation of Unstable Solids Circulation Behavior in A Circulating Fluidized Bed with Sweeping Bend Return Using Pressure Frequency Analysis

Impact of Loop Seal Structure on Gas Solid Flow in A Cfb System

Gas−Solid Flow Behavior in the Standpipe of a Circulating Fluidized Bed with a Loop Seal

Computational Fluid Dynamics–Discrete Element Method Investigation of Pressure Signals and Solid Back-Mixing in a Full-Loop Circulating Fluidized Bed

Control of Pressure Balance and Solids Circulation Characteristics in DCFB Reactors

Pressure Balance In A Circulating Fluidized Bed

Heat Transfer in a Pressurized Circulating Fluidized Bed

Application of CPFD Method in the Simulation of a Circulating Fluidized Bed with a Loop Seal, Part I—Determination of Modeling Parameters

Experimental Study on the Performance of Loop-Seal in a Horizontal Circulating Fluidized Bed Boiler