Abstract:To investigate the relationship between macro-plastic behavior and meso-deformation mechanism of Mg alloy AZ31, the mathematical models for various deformation mechanisms of slip, twinning and detwinning are established, respectively. Furthermore, in order to capture the Bauschinger effect under cyclic loading, the back stress is introduced into the three independent deformation mechanisms, respectively. Finally, using the above-mentioned model, a new cyclic plastic constitutive model based on the constitutive theory of crystal deformation for magnesium alloy is established. On this basis, the numerical simulation for AZ31 under cyclic loading with the axial strain amplitude of 1.2% is carried out in accordance with the aforementioned crystal plasticity theory associated with the representative volume element model. The comparison between the stress–strain curves obtained from the simulation and the experiments shows that the macroscopic mechanical responses predicted using the proposed model are in good agreement with the experimental results. In particular, the unique characteristics of cyclic macro-plastic behavior observed in the experiments can be satisfactorily captured by the presented crystal plasticity model. At the mesoscale, these features are caused by the alternate occurrence of twinning and detwinning mechanisms. The further analysis of meso-plastic behavior shows that there are heterogeneous distributions of twinning, stress–strain and stress triaxiality in polycrystal under cyclic loading.

A Thermodynamically Consistent Distortional Hardening Model for AZ31 with Experimental Validation

Thermodynamically Consistent Directional Distortional Hardening of Mg Alloy: Experiments and Constitutive Modeling

Thermodynamically Consistent Constitutive Modeling of Distortional Hardening for Wrought Mg Alloys under Non-Proportional Loading

Loading path dependent distortional hardening of Mg alloys: Experimental investigation and constitutive modeling on cruciform specimens

A Generalized Thermodynamically Consistent Distortional Hardening Model for Mg Alloys

Dynamic plasticity of AZ31 magnesium alloy: Experimental investigation and constitutive modeling

A New Constitutive Model for Thermal Deformation of Magnesium Alloys

The Anisotropic Distortional Yield Surface Constitutive Model Based on the Chaboche Cyclic Plastic Model.

Plastic Flow Characteristics and Physical Conception Constitutive Relation for AZ31 Cast Magnesium Alloy

A Kinematic Hardening Constitutive Model for the Uniaxial Cyclic Stress–strain Response of Magnesium Sheet Alloys at Room Temperature

Numerical simulation of plastic behavior and meso inhomogeneous deformation in AZ31 Mg alloy

An Accurate Constitutive Model for AZ31B Magnesium Alloy during Superplastic Forming

Experiment and Modeling of Plastic Anisotropy for AZ31B Mg-Alloy

Investigation on the inhomogeneous deformation of magnesium alloy during bending using an advanced plasticity model

Anisotropic-Asymmetric Hardening Characterization of BCC/FCC/HCP Metals: Experiments and Modeling

Constitutive Modeling of Slip, Twinning and Detwinning for Mg Alloy and Inhomogeneous Evolution of Microstructure

Mg-3Al-1Zn alloy deformed along different strain paths: Role of latent hardening

A Modified Johnson–Cook Constitutive Model for Characterizing the Hardening Behavior of Typical Magnesium Alloys under Tension at Different Strain Rates: Experiment and Simulation

Forming Limit Diagram Analysis Based on Crystal Plasticity for Magnesium Alloy Sheets

Modeling of Anisotropic and Asymmetric Behaviour of Magnesium Alloys at Elevated Temperature Coupled with Ductile Damage

Constitutive Model Development and the Numerical Study on the Drawability of AZ31 Sheet