Abstract:In this article, the partial discharge (PD) excitation characteristics of SF 6 /N 2 gas mixtures on the epoxy insulation surface under AC/LI (Alternating Current and Lightning Impulse) superimposed voltages are investigated. The phenomenon of PD excitation in SF 6 /N 2 gas with 20% SF 6 content is explained in detail. The effects of SF 6 /N 2 gas mixtures ratio and the polarity on the PD characteristics under subsequent AC voltage are analyzed. It found that under the influence of AC/LI superimposed voltages, there are significant differences in the PD initiation characteristics between SF 6 /N 2 gas with SF 6 content less than 60% and pure SF 6 . In SF 6 /N 2 gases, the AC superimposed phase that can initiate subsequent discharge is larger, and when superimposed voltages is applied in the positive (or negative) half-cycle of AC to initiate discharge, in pure SF 6 , the discharge only occurs in the subsequent AC’s negative (or positive) half-cycle. However, in SF 6 /N 2 gas mixtures with SF 6 content less than 60%, the discharge can occur in both the positive and negative half-cycles of AC. In addition, the PD phenomenon after AC/PLI superimposed voltages is more prominent than AC/NLI superimposed voltages. The severity of PD under subsequent AC increases with the decrease of AC voltage duration experienced from the superposition moment to the first zero crossing point of the AC voltage.

PD Characteristics of Metal Particle on Epoxy Surface Under AC Superimposed Lightning Impulse in SF6

PD Characteristics of Epoxy Surface Triggered by Metal Particle under AC Superimposed Lightning Impulse in SF6 Gas

Partial Discharge Measurement and Analysis under Lightning Impulse Superimposed DC Voltage in SF6 Gas

Partial discharge characteristics of epoxy insulation surface under AC/LI superimposed voltages in SF<sub>6</sub>/N<sub>2</sub> gas mixtures

Characteristics of AC PDs on Epoxy Insulation Surface Excited by Different Impulse Voltages in SF6 Gas

Study on the Partial Discharge Characteristics of Epoxy Insulation Surface after Repeated Lightning Impulses in SF6Gas

Partial Discharge Characteristics of Typical Insulation Defect under AC and Impulse Superimposed Voltage in SF6 Gas

PD Characteristics of Void in Epoxy Insulation under AC and Impulse Superimposed Voltage

Study on the Influence of Switching Impulse Superposition Phase on AC Partial Discharge of Epoxy Surface in SF<sub>6</sub> Gas

Characteristics of the Partial Discharge-induced Current along Epoxy Resin Film under Superimposed AC-DC Voltage

Effect of AC and Switching Impulse Superimposed Voltage on PD Characteristics in SF6 Gas

Partial Discharge Characteristics over Sf6/Epoxy Interfaces under Impulse Voltage

Surface Charge Accumulation and Pre-Flashover Characteristics Induced by Metal Particles on the Insulator Surfaces of 1100 Kv GILs under AC Voltage

Partial Discharge Measurement and Analysis at Standard Oscillating Switching and Lightning Impulses on A Gis with Artificial Protrusion Defects

Partial Discharge Test under Standard Oscillating Impulses on a Gas-Insulated Bus with Artificial Metal Particle Defects on the Insulator Surface

Partial discharges triggered by metal-particle on insulator surface under standard oscillating impulses in SF 6 gas

Partial Discharges in SF6 Gas Filled Void under Standard Oscillating Lightning and Switching Impulses in Uniform and Non-Uniform Background Fields

Partial Discharge Characteristics of Submillimeter Metal Particles on the Insulator Surface in GIS with Long-time AC Stress

Characteristics of the Partial Discharge in the Development of Conductive Particle-Initiated Flashover of a GIS Insulator

Partial discharges characteristics of harmful conducting particles around spacer under ac voltage in atmospheric air

Discharge Characteristics and Harmfulness of Millimetre Metal Particles on the 1100 Kv Insulator Surface