Abstract:Gas insulated switchgear (GIS) is widely used in power system. With the increase of voltage level and substation scale, filed impulse voltage withstand test is increasingly important to ensure GIS safety as AC voltage withstand test becomes non-effective for the exposure of all defects. Standard lightning impulse (SLI) is normally adopted in factory, whereas oscillating lightning impulse (OLI) is more suitable for field use for its high generation efficiency. Thus discharge characteristics of typical defect in GIS under OLI need to be studied. Sharp protrusions on conductor are typical defects in GIS and are critical at lightning impulse voltages. This paper therefore aims to study discharge characteristics of protrusion on conductor under OLI. An impulse voltage generator was first established to generate four oscillating lightning impulses. A 12 mm long protrusion defect was then set up on conductor in a 330 kV GIS chamber. There was an ultra high frequency (UHF) sensor in the neighboring chamber to measure partial discharge (PD) and a voltage divider was used to measure applied voltage waveform. PD characteristics, 50% probability breakdown voltage (BDV50) and Voltage-time characteristics (V-t characteristics) were experimentally studied. The results show that breakdowns always occur in the vicinity of each wave peak under OLI. Obvious polarity effect exists that BDV50 is much lower for positive polarity. Wavefront has strong influence on the discharge characteristics. For positive polarity, short wavefront indicates that first streamer discharge will directly lead to breakdown. Pre-breakdown discharge is followed by breakdown when wavefront is longer, in which corona stabilization effect is observed. For negative polarity, corona stabilization effect is more obvious. Breakdowns first occur in the third oscillating period with 1.2 μs wavefront and there exists PDs in the first and second period. With 13 μs wavefront, breakdowns only occur in the first period. The results of the study are expected to provide important clues for the choosing of voltage waveform and analysis of test results in field test for GIS.

Partial Discharge Measurement and Analysis at Standard Oscillating Switching and Lightning Impulses on A Gis with Artificial Protrusion Defects

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Partial Discharge Pulses at Artificial Protrusions in SF 6 under Negative IEC60060-3 Standard Impulses

Partial Discharges in Void Defect of Gas Insulated Switchgear Insulator under Standard Aperiodic and Oscillating Switching Impulses

Partial Discharge Test under Standard Oscillating Impulses on a Gas-Insulated Bus with Artificial Metal Particle Defects on the Insulator Surface

Partial Discharge Measurement under an Oscillating Switching Impulse: A Potential Supplement to the Conventional Insulation Examination in the Field

Partial Discharge Characteristics of Surface Defect in SF 6 Under Oscillating Impulse Voltage

Partial Discharges in SF6 Gas Filled Void under Standard Oscillating Lightning and Switching Impulses in Uniform and Non-Uniform Background Fields

Partial Discharge Characteristics of Metallic Protrusion in GIS under Different Lightning Impulse Voltage Waveforms Based on UHF Method

Characteristics and Development Mechanisms of Partial Discharge in Sf6 Gas under Impulse Voltages

Partial Discharge and Breakdown of Protrusion on Conductor in GIS under Oscillating Lightning Impulses

Partial Discharge Detection and Analysis of Needle-Plane Defect in SF6 under Negative Oscillating Lightning Impulse Voltage Based on UHF Method

Partial Discharge Characteristics over Sf6/Epoxy Interfaces under Impulse Voltage

Partial discharges triggered by metal-particle on insulator surface under standard oscillating impulses in SF 6 gas

Research On Partial Discharge Characteristics Of Protrusion Defect In Gis Under Oscillating Lightning Impulse Voltage

Partial Discharges in SF6 Gas Filled Void under Standard Aperiodic and Oscillating Switching Impulses

Partial Discharge Characteristics of Typical Defect of SF6 Gas Insulation Under Impulse Voltage

Characteristics of the Partial Discharge in the Development of Conductive Particle-Initiated Flashover of a GIS Insulator

Effect of AC and Switching Impulse Superimposed Voltage on PD Characteristics in SF6 Gas

PD Detection under Impulse Voltage on an Actual SF6 Bus Section with Protrusion Defects Fixed on HV Conductor

Partial Discharge Detection in Gas-Insulated Switchgears Using Sensors Integrated with UHF and Optical Sensing Methods