Abstract:Mechanical defects are one of the main reasons of GIS equipment failure. However, there are no available detection devices and mechanical defects assessment methods for GIS mechanical fault diagnosis. Firstly, the mechanism of mechanical vibration of GIS is deeply studied in this paper. On the basis of the research on the source and detection method of GIS vibration signal, the vibration acceleration sensor is used as the sensor to develop the GIS vibration signal detection device. Secondly, the GIS mechanical vibration test platform is built in the laboratory, and the spring contact loose defect of the GIS bus connector is set up on the test platform. Then the vibration test of the GIS shell was carried out on the condition that the bus connector is normal and the connection of connector is loose using the self-developed vibration signal detection device. Finally, the vibration signal characteristics of normal and loose defect are extracted based on the spectrum analysis method. The connection state evaluation method and judgment basis of GIS bus connector are given. The result indicates that obvious vibration signal can be detected in GIS shell near insulator. In normal operation, the vibration signals in all directions to the GIS shell have the same characteristics that obvious vibration signals at 100Hz frequency as well as in the frequency range of 1000Hz-2000Hz can be found. In particular, the amplitude of vibration signal at 1400Hz is almost equal to that at 100Hz. When GIS bus connector has a loose contact, the amplitude of vibration signal is relative high and closely related to direction. Take the amplitude of 100Hz as the reference value, the ratio of amplitudes between 1400Hz and 100Hz can be regarded as the characteristic quantity indicating the connection state of bus connector. The connector can be convinced of loose contact while the ratio is larger than 2 or smaller than 0.5 inferring from the experimental data in laboratory.

Evaluation method of contact state of GIS disconnector based on multi-feature fusion

GIS Mechanical State Identification and Defect Diagnosis Technology Based on Self-Excited Vibration of Assembled Circuit Breaker

Condition Assessment Method of GIS Disconnector Based on Vibration- Thermal-Electrical Multi-Parameter Signal Characteristics

Research Of The Vibration Characteristics In Gis Disconnector Under Different Contact State

Computation of Transient Electromagnetic Field Emission from GIS Enclosure During Disconnector Switching Operations

Partial Discharge Detection and Defect Location Method in GIS Cable Terminal

Research on state assessment method of subway 35kv switchgear based on multi-feature quantities

Multiscale Fusion Simulation of the Influence of Temperature on the Partial Discharge Signal of GIS Insulation Void Defects

Study on Temperature Rise Characteristics of GIS Disconnector Under Different Operating Conditions

Statistical Feature Extraction Combined with Generalized Discriminant Component Analysis Driven SVM for Fault Diagnosis of HVDC GIS

Inversion Method for Contact Temperature of GIS Disconnect Switch

Research of Mechanical State Diagnosis Techniques in GIS Bus Connector Based on Mechanical Vibration

Discharge Identification for SF6 Gas-Insulated System Applying Multi-Physical Information Fusion

Property Comparison and Evaluation Method for Ultra-High-Frequency Sensors Installed on GIS Based on Transfer Function

Gas Insulated Switchgear Partial Discharge Type Identification Based on Frequency Division Features and Improved Long Short-Term Memory Neural Networks

Measurement and Analysis of Partial Discharge on Floating Electrode Defect in GIS

A Novel Composite Sensor for UHF Partial Discharge and Gas State Measurement in GIS

Research on the Method and Device for Judging the Position and Status of GIS Disconnectors

Investigation of the Evaluation of the Pd Severity and Verification of the Sensitivity of Partial-Discharge Detection Using the Uhf Method in Gis

Contact Temperature Monitoring and Layout Optimization of Shell Temperature Sensor of 500kv GIS

Research on 1 100 kV GIS Partial Discharge Fault Location Based on UHF Technology