Abstract:Optical fibers are drawn from preforms (fused silica glass rods) typically made up of two concentric cylinders (the core rod and the clad tube), which are usually joined in a separate fusion process. The setup time and hence manufacturing cost can be significantly reduced if the two cylinders can be joined in the same furnace in which the fiber is drawn. A good understanding of the transient temperature distribution is needed for controlling the feed rate to avoid thermally induced cracks. Since direct measurement of the temperature fields is often impossible, the geometrical design of the preform and the control of the feed rate have largely been accomplished by trials-and-errors. The ability to predict the transient temperature distribution and the thermally induced stresses will provide a rational basis to design optimization and feed rate control of the process. In this paper, we present an analytical model to predict the transient conductive-radiative transfer as two partially joined, concentric glass cylinders with specular surfaces are fed into the furnace. Finite volume method (FVM) is used to solve the radiative transfer equation (RTE). The specular surface reflectivity is obtained by the Fresnel’s law and the Snell’s law. The boundary intensities are obtained through the coupling of the interior glass radiative transfer and the exterior furnace enclosure analysis. The model has been used to numerically study the transient conductive-radiative transfer in the advanced melting zone (AMZ) of an optic fiber drawing process. This problem is of both theoretical and practical interest in the manufacture of optical fibers. The computational method for the radiation transfer developed in this paper can also be applied to the simulation of the fiber drawing process and other glass-related manufacturing processes.

Control of Stress Distribution During Large Radius Fiber Optic Taper Drawing Process Based on 2D Simulation

Theoretical and Numerical Analysis for Design of High Ratio Fiber Optic Taper Drawing Process

Modeling bending losses of optical nanofibers or nanowires.

Computer Aided Fiber Path Design to Torus in Filament Winding

Modeling of Tension Control System with Passive Dancer Roll for Automated Fiber Placement

Coupled heat and fluid transport in pulled extrusion of cylinders

Numerical study on the internal stress of optical fiber connector in the aerospace wide temperature range

Modeling of Advanced Melting Zone for Manufacturing of Optical Fibers

Rheological Properties of Fiber Suspensions Flowing Through a Curved Expansion Duct

The Stress-Microstructure Relationship in an Evolving Mixing Layer of Fiber Suspensions

Fabrication Methods and High-Precision Diameter Control Techniques of Optical Micro-/Nanofibers

A Numerical Model to Reduce Thermal Residual Stress During Cooling and Annealing Process of Large Optical Glass Production

Numerical Study and Scale Analysis of Inner and Outer Diameters Prediction in Fabrication of Hollow Fiber Membranes for Nerve Regeneration

Theoretical analysis of tapering fused silica optical fibers using a carbon dioxide laser

High Spatial Resolution Internal Stress Testing and Analysis of Fiber Optic Winding Structure Using BOTDA

Experimental Research on Thermo-Direct Fiber Drawing Technique

Numerical simulation of fiber orientation distribution in round turbulent jet of fiber suspension

Optical Fiber Index Taper–Theoretical Analysis and Experiment Demonstration

Orientation Distribution and Rheological Properties of Fiber Suspensions Flowing Through Curved Expansion and Rotating Ducts

OTDR-based optical fiber bending and tensile loss analysis

Unraveling radial dependency effects in fiber thermal drawing