Abstract:This paper presents the experimental development and analytical modelling of cost-effective Optical Fiber Tweezers fabricated from tapered optical fibers. The optical fiber tweezers use a 976 nm pump laser to obtain the multimode effect in conventional silica optical fibers (since it is below the cutoff wavelength). In addition, the taper is performed in the optical fiber using a conventional optical fiber splicing machine, where the diameter of the taper can be controlled by simply changing the taper parameters. The simplified analytical model is performed for the analysis of the intensity and optical power variations of the fiber tip as a function of the axial distance and angle between the fiber tip and the region of interest as well as the attractive (or repulsive) force on the optical field. In this case, 3 optical fiber tweezers were fabricated with different tip diameters and tested as a function of two set of particle specimens, one using polystyrene with 17 μ m diameter and the other with glass particles of 3.2 μ m. Results show that the repulsive forces presented in the force estimation model do not occur as expected, where all optical fiber tweezers presented higher attractive forces than the expected by the analytical model. Such differences can be related to the phototermal effect, which may have led to an unbalanced relation between its sub-effects known as thermophoresis and negative photophoresis. The results also indicated a high dependency of the attractive forces as a function of the optical fiber tip diameter, where the fiber tweezer with smallest diameter presented a fivefold and fourfold increase in the optical force when compared with the fiber tweezer with highest diameter for polymer and glass particles, respectively. Therefore, the proposed approach is a cost-effective method with relatively large control of the optical fiber tip for the optical actuator of micro-scale particles.

Theoretical analysis of tapering fused silica optical fibers using a carbon dioxide laser

Supercontinuum Generation in Submicrometer Diameter Silica Fibers

Optical Fiber Index Taper–Theoretical Analysis and Experiment Demonstration

Theoretical and Numerical Analysis for Design of High Ratio Fiber Optic Taper Drawing Process

Experimental stress-strain analysis of tapered silica optical fibers with nanofiber waist

Novel fiber taper for efficient optical interconnection

Control of Stress Distribution During Large Radius Fiber Optic Taper Drawing Process Based on 2D Simulation

Optical nanofibers and spectroscopy

Optically active mechanical modes of tapered optical fibers

Toward Little Heat-Affected Area of Fused Silica Materials Using Short Pulse and High Power CO2 Laser

Demonstration of CO2-laser power delivery through chalcogenide-glass fiber with negative-curvature hollow core

Comparative modal analysis in micro–nano-optical fiber tapers using spectral parameter power series method and exact modes method

Theoretical Analysis and Heat Dissipation of Mid-Infrared Chalcogenide Fiber Raman Laser

Theoretical analysis of the heat dissipation mechanism in high power photonic crystal fiber lasers

Role of Fictive Temperature Distribution Involved in CO2 Laser Polishing of Fused Silica and Its Optimization for Achieving Even Heat-Affected Zones

Numerical and Experimental Investigation of Morphological Modification on Fused Silica Using CO2 Laser Ablation

A Versatile Model for Temperature-Dependent Effects in Tm-Doped Silica Fiber Lasers

Experimental evaluation of a hollow glass fiber

Experimental and analytical analysis of tapered optical fiber tweezers

Feedback-cooling the fundamental torsional mechanical mode of a tapered optical fiber to 30 mK

Modeling of Advanced Melting Zone for Manufacturing of Optical Fibers