Abstract:Introduction: To investigate the ablation efficiency of super-pulse thulium fiber laser (SPTFL) with different laser settings and fiber usage. Materials and Methods: SPTFL machine was attached with different fibers. Artificial stones were fixed in water, whereas laser fiber was driven on a platform for ablation. Pulse energy, frequency, fiber-moving speed, fiber-to-stone distance, and fiber size were adjusted in each trial. The cross-sectional area of craters on the lateral stone surface was measured for comparison of ablation rate, combined with fiber-moving speed. Results: There was a trend that the ablation rate increased as pulse energy or frequency increased. When pulse energy was set as 0.2 J and frequency was increased from 50 to 150 Hz, the cross-sectional area of the crater was enlarged from 0.21 to 0.37 mm(2) (p < 0.05); when the frequency was set as 100 Hz and pulse energy was increased from 0.1 to 0.3 J, the crater was enlarged from 0.10 to 0.45 mm(2) (p < 0.05). Furthermore, energy demonstrated greater impact on ablation rate and the crater was enlarged from 0.20 mm(2) in the 0.1 J x 300 Hz group to 0.44 mm(2) in the 0.3 J x 100 Hz group (p < 0.05). Then fiber was set at different moving speeds with the same laser setting; the ablation rate of 3 mm/second group was 3.64 times higher than 0.5 mm/second group (p < 0.05). Ablation diminished as fiber-to-stone distance grew. A 200 mu m fiber produced thinner and deeper fissure than 272 and 550 mu m fibers, and the ablation rate was the highest for the 200 mu m fiber. Conclusion: Pulse energy is a more important factor in influencing ablation efficiency compared with frequency. Closer fiber-to-stone distance, faster fiber movement, and smaller fiber size increase ablation efficiency.

A Low Diffraction Laser Beam As Applied to Polymer Ablation

Experimental Investigation of Polymeric Material Removal by Low Diffraction Laser Beam

Sub-diffraction Optical Beam Lithography Based on a Center-Non-zero Depletion Laser

Transient Ablation Model for Laser Machining Polymer Microfluidic Chip

Ablation Efficiency of a Novel Thulium Fiber Laser: an in Vitro Study on Laser Setting and Fiber Usage.

Radiative Ablation to Low-Z Matter

Analysis of the Dynamics of Laser Ablation of Polymers

Laser Beam Smoothing by Rotating Random Phase Plate

A New Beam Co2-Laser

New beam CO2 laser

Laser Beam Characteristic for Laser Resonators with Diffraction Optical Elements

The Research on Improving the Characteristics of Laser Output with Diffractive Optical Elements

Manipulating the performance of polymer lasers using diffraction elements

Numerical and experimental analysis of dynamic process of laser ablation epoxy resin

Simulation of evaporation ablation dynamics of materials by nanosecond pulse laser of Gaussian beam and flat-top beam

Experimental probe into the femtosecond laser ablation thresholds in carbon fiber reinforced polymer and assessment of the measurement theories

Laser Beam Shaping Using a Photoinduced Azopolymer Droplet-Based Mask

Polymer-coated hollow fiber for CO(2) laser delivery.

Direct Laser Interference Ablating Nanostructures on Organic Crystals

Laser–Material Interactions of High-Quality Ultrashort Pulsed Vector Vortex Beams

Numerical Study of Thrust Generation in the Process of Laser Ablated Doped Polymer