Abstract:As we know, 3DPC is printed layer by layer compared with mold-casting conventional concrete. Pore structure and layer-to-layer interface are two main aspects of the internal structure for 3DPC, which decide 3DPC's mechanical performance. The layer-to-layer interface caused by printing is specific to 3DPC. The emphasis of this study lies in the layer-to-layer interfaces of 3DPC. The first aim of this study is to quantify the characteristics of the layer-to-layer interface and therefore characterize different aspects of the interfaces. The second aim of this study is to explore how the internal structure of printed concrete influences the mechanical performance of 3DPC. This research set out to design a series of experimental comparisons between 3DPC and casted concrete with the same compositions. Mechanical tests, i.e., compressive stress, ultrasonic Pulse Velocity test, flexural tension, and tension splitting, as well as the Ultrasonic Pulse Velocity test, were performed to check the mechanical performance of 3DPC. Contrary to what has often been expected, the mechanical test results showed the printed concrete has a quality not worse than casted concrete with the same recipe. Meanwhile, the X-ray computed tomography (X-CT) is used to characterize the internal structure, pore shapes, and interfaces of 3DPC. First, the investigation revealed that the lower total porosity and fewer big voids could be the fundamental causes meaning 3DPC has a better mechanical performance than casted concrete. Second, the statistics based on aspect ratio show that the distribution curves follow similar trends, regardless of the printed or casted concrete. Third, this study quantified the depth of the different interfaces for 3DPC. The results suggest that the porosity in an interface varies in a range. The author's pioneer work has contributed to our present understanding of the interfaces of 3DPC.

Mechanical Properties and Pore Structure of 3D Printed Mortar with Recycled Powder

Mortar with Substituted Recycled PET Powder: Experimental Characterization and Data-Driven Strength Predictive Models

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Comparative Evaluation of the Applicability of 3D Printing Mortar with Different Waste Powders

Mechanism of the influence of multi-scale pore structure on the triaxial mechanical properties of 3D printed concrete with recycled sand

Dynamic Properties and Fractal Characteristics of 3D Printed Cement Mortar in SHPB Test

3D printed concrete with recycled sand: Pore structures and triaxial compression properties

Systematic approach for printability evaluation and mechanical property optimization of spray-based 3D printed mortar

Mechanical Performance Optimization in Spray-Based Three-Dimensional-Printed Mortar Using Carbon Fiber

Shrinkage and Cracking Performance of PP/PVA Fiber-Reinforced 3D-Printed Mortar

THE RESPONSE OF THE SINO-ATRIAL NODE TO RAPID ATRIAL STIMULATION

Influence of pore defects on the hardened properties of 3D printed concrete with coarse aggregate

Plastic shrinkage and cracking of 3D printed mortar with recycled sand

Mechanical Properties of Structures 3D Printed with Cementitious Powders

Effect of nano clay and PCE on the buildability of ultra-fine dredged sand-based 3D printing materials

Improving mechanical properties of 3D printed mortar by exploiting synergistic effects of fly ash microsphere and nano-silica

Experimental and numerical analysis of 3D printed cement mortar specimens using inkjet 3DP

Modification effect of nanosilica and polypropylene fiber for extrusion-based 3D printing concrete: Printability and mechanical anisotropy

Hardened properties of 3D printed concrete with recycled coarse aggregate

Influence of Hydroxypropyl Methylcellulose Dosage on the Mechanical Properties of 3D Printable Mortars with and without Fiber Reinforcement

Mechanical and macrostructural properties of 3D printed concrete dosed with steel fibers under different loading direction