Abstract:As we know, 3DPC is printed layer by layer compared with mold-casting conventional concrete. Pore structure and layer-to-layer interface are two main aspects of the internal structure for 3DPC, which decide 3DPC's mechanical performance. The layer-to-layer interface caused by printing is specific to 3DPC. The emphasis of this study lies in the layer-to-layer interfaces of 3DPC. The first aim of this study is to quantify the characteristics of the layer-to-layer interface and therefore characterize different aspects of the interfaces. The second aim of this study is to explore how the internal structure of printed concrete influences the mechanical performance of 3DPC. This research set out to design a series of experimental comparisons between 3DPC and casted concrete with the same compositions. Mechanical tests, i.e., compressive stress, ultrasonic Pulse Velocity test, flexural tension, and tension splitting, as well as the Ultrasonic Pulse Velocity test, were performed to check the mechanical performance of 3DPC. Contrary to what has often been expected, the mechanical test results showed the printed concrete has a quality not worse than casted concrete with the same recipe. Meanwhile, the X-ray computed tomography (X-CT) is used to characterize the internal structure, pore shapes, and interfaces of 3DPC. First, the investigation revealed that the lower total porosity and fewer big voids could be the fundamental causes meaning 3DPC has a better mechanical performance than casted concrete. Second, the statistics based on aspect ratio show that the distribution curves follow similar trends, regardless of the printed or casted concrete. Third, this study quantified the depth of the different interfaces for 3DPC. The results suggest that the porosity in an interface varies in a range. The author's pioneer work has contributed to our present understanding of the interfaces of 3DPC.

THE RESPONSE OF THE SINO-ATRIAL NODE TO RAPID ATRIAL STIMULATION

Mortar with Substituted Recycled PET Powder: Experimental Characterization and Data-Driven Strength Predictive Models

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Bond shear performances and constitutive model of interfaces between vertical and horizontal filaments of 3D printed concrete

Plastic shrinkage and cracking of 3D printed mortar with recycled sand

3D printed concrete with recycled sand: Pore structures and triaxial compression properties

Mechanism of the influence of multi-scale pore structure on the triaxial mechanical properties of 3D printed concrete with recycled sand

Interfacial bonding properties of 3D printed permanent formwork with the post-casted concrete

3D printing concrete with recycled coarse aggregates: The influence of pore structure on interlayer adhesion

Dynamic Properties and Fractal Characteristics of 3D Printed Cement Mortar in SHPB Test

Mechanical Performance Optimization in Spray-Based Three-Dimensional-Printed Mortar Using Carbon Fiber

Systematic approach for printability evaluation and mechanical property optimization of spray-based 3D printed mortar

Interfacial Properties of Three-Dimensional-Printed Permanent Formwork with Cast-in-Place Concrete

Interfacial constitutive model of 3D printed fiber reinforced concrete composites and its experimental validation

Interlayer Shear Strength of Roller Compacted Concrete (RCC) with Various Interlayer Treatments

Comparative Evaluation of the Applicability of 3D Printing Mortar with Different Waste Powders

Shear behaviors of engineered cementitious composites to seawater sea-sand concrete (ECC-to-SSSC) interfaces cast using 3D-printed pre-grooving formwork: Mechanical properties, characterization, and life-cycle assessment

Testing Mortars for 3D Printing: Correlation with Rheological Behavior

Adhesion studies in view of automated repair using 3D concrete printing

Interfacial bonding performance of 3D-printed Ultra-High Performance Strain-Hardening Cementitious Composites (UHP-SHCC) and cast normal concrete

Influence of pore defects on the hardened properties of 3D printed concrete with coarse aggregate