Abstract:Cu-matrix composites, with a constant graphite content but different proportions, for high-speed trains were prepared by a powder metallurgy technique. A reduced proportion pin-disc testing machine was used to study the braking performances of friction materials at different speeds. The results show that the microhardness and resistance to plastic deformation of the friction surface are significantly affected by the proper introduction of colloidal graphite. Compared with copper-plated graphite, colloidal graphite has more active surface free energy and can react readily with Fe to produce cementite. Cementite is a kind of metal compound with high strength that has a great supporting effect on the material surface. The cementite participates in the formation of a friction layer. As a result, the strength of the friction film is improved and the oxidation of Fe is reduced, leading to the generation of a friction film with strong antideformation ability. The transfer of material from the friction surface during high-energy braking is low, which stabilizes the coefficient of friction and decreases the wear volume. However, too many colloidal graphite particles results in many interfaces in the matrix and severely damage the matrix's continuity. With an increase in colloidal graphite mass fraction, the arrangement direction of the copper-plated graphite changes. When the colloidal graphite content is 1% and the copper-plated graphite content is 19%, the friction material shows a stable friction coefficient and has good tribological properties under high-speed braking at 350 km/h.

Simulation of Effect of Force Chain on Graphite Migration of Copper Based Graphite Composites During Friction

Using DEM method to study graphite migration of copper-based graphite composites during friction

Infiltration behavior of copper melt into porous graphite and saturation improvement by WC particles doping

Friction and Wear Behavior of Copper-Graphite Composite Material in High-Speed Sliding with Current

Effect of Graphite Content on Cu–Ni–Graphite Composite for Use As Switch Slide Baseplate Materials Sliding Against U75V Steel

Effects of Graphite Contents on the Microstructure Evolution, Mechanical Properties and High Temperature Tribological Behavior of Cu–Ni–Al/Gr Solid-Lubricating Composites

Tribological Behavior of Phenolic Resin-Based Friction Composites Filled with Graphite

Effect of Graphite Particle Reinforcement on Dry Sliding Wear of SiC/Gr/Al Composites

Investigation of Tribological Behavior of Polytetrafluoroethylene/graphene Composite

Anisotropic Friction Behavior of Aligned and Oriented Graphite Flakes/copper Composite

Anisotropic Friction Derived from the Layered Arrangement of the Oriented Graphite Flakes in the Copper–Iron Matrix Composite

Effect of Bimodal Structure on the Frictional Properties of Copper–Graphite Composites

Synergistic Effects of Different Graphite on the Braking Performance of Cu-Matrix Friction Materials for High-Speed Trains Based on Pin–Disc Tests

On the tribological behaviors of Cu matrix composites with different Cu-coated graphite content

Influence of a Carbon-Based Tribofilm Induced by the Friction Temperature on the Tribological Properties of Impregnated Graphite Sliding Against a Cemented Carbide

Effect of Purity and Proportion of Microcrystalline Graphite Ore on the Electrical, Mechanical and Tribological Performance of Copper-Carbon Composites

Tribological behaviors of Ag−graphite composites reinforced with spherical graphite

Enhanced mechanical and tribological properties of copper matrix composites reinforced by copper-coated graphite and Ti3AlC2

Tribological behaviors of graphite/epoxy two-phase composite coatings

Effect of Physical Properties of Cu-Ni-graphite Composites on Tribological Characteristics by Grey Correlation Analysis

Friction and wear properties of copper matrix composites reinforced with short carbon fibers