Abstract:This paper presents the results of a study of layer gradient thermal protection coatings based on NiCrAlY and YSZ obtained by detonation spraying. Modern gas turbines and high-temperature units operate under extreme temperatures and aggressive environments, which requires effective protection of components from wear, corrosion, and thermal shocks. In this study, the use of layer gradient coatings consisting of alternating layers of NiCrAlY and YSZ was investigated with the aim of solving the problem of thermal stress accumulation due to a smooth change in the composition of the layers. Microstructural and phase analysis showed that alternating layers of NiCrAlY and YSZ formed a dense layer gradient structure with clear interphase boundaries and low porosity. Detonation spraying led to a complete transformation of the monoclinic ZrO2 phase into a tetragonal one, which significantly increased the mechanical strength of the coating and its resistance to thermal shocks. Sample 1D1 demonstrated excellent tribological and corrosion properties in a 3.5% NaCl solution, which can be explained by its higher density and reduced number of pores. Mechanical tests revealed stable values of hardness and wear resistance of the coating, especially for the 1D1 coating. Studies have shown that coatings are resistant to thermal shocks, but thicker layers show a tendency to peel off after thermal cycling. The obtained results indicate high prospects for the use of layer gradient coatings based on NiCrAlY and YSZ for the protection of gas turbine components and other high-temperature installations operating under extreme loads and aggressive environments.

Microstructure and Phase Correlation of Dysz-Polyester Abradable Seal Coating after Thermal Exposure

Evaluation of an AlSi-polyester abradable seal coating performance using high-temperature and high-velocity abrasion tests

Study on Thermal Shock Behavior of YSZ Abradable Sealing Coating Prepared by Mixed Solution Precursor Plasma Spraying

Preparation and Characterization of YSZ Abradable Sealing Coating Through Mixed Solution Precursor Plasma Spraying

A Study on YSZ Abradable Seal Coatings Prepared by Atmospheric Plasma Spray and Mixed Solution Precursor Plasma Spray

Phase transitions and microstructure evolutions of in-situ YSZ-ZrC composite coating under long-time plasma torch ablation

Microstructural and Mechanical Property Evolutions of Plasma-Sprayed YSZ Coating During High-Temperature Exposure: Comparison Study Between 8YSZ and 20YSZ

Failure Analysis of Fine-Lamellar Structured Ysz Based Thermal Barrier Coatings with Submicro/Nano-Grains

Evolution of Microstructure, Thermophysical and Mechanical Properties and Wetting Behavior of Plasma-Sprayed Yb2O3 and Y2O3 Co-Stabilized ZrO2 Coatings During High-Temperature Exposure and CMAS Corrosion

High Temperature Oxidation and Insulation Behavior of Plasma-Sprayed Nanostructured Thermal Barrier Coatings

Investigation of microstructure changes in Al2O3-YSZ coatings and YSZ coatings and their effect on thermal cycle life

Superior toughness of thermal barrier coating caused by co-doping of trivalent and pentavalent oxides

Structural evolution and phase transformation behaviors of 10 wt. % dysprosia stabilized zirconia ceramic powders

Comparison of Temperature Dependent Deformation Mechanisms of 8YSZ Thermal Barrier Coatings Prepared by Air-Plasma-spray and D-gun Thermal Spray: an in Situ Study

Aging Properties of Yttria-Stabilized Zirconia Ceramics

Fabrication, Mechanical Properties and Abrasibility of YSZ/BN@ZrO2 Coating with Core-Shell-structured Feedstocks by Atmospheric Plasma Spraying

Fabrication and characterization of 8YSZ ceramic based abradable seal coatings by atmospheric plasma spraying

Microstructure and Properties of Sputtered Thermal Barrier Coatings

Investigation of Structural Phase, Mechanical, and Tribological Characteristics of Layer Gradient Heat-Protective Coatings Obtained by the Detonation Spraying Method

Enhanced CMAS and hot corrosion degradation of YSZ thermal barrier coating with nano powders

Assessment of the Performance of Y2SiO5-YSZ/YSZ Double-Layered Thermal Barrier Coatings