Abstract:Temperature plays an important impact on rock mechanical properties. In this paper, the mechanical properties, fracture mechanism and constitutive model of marble under 20–120 °C and 15 MPa are studied. The results show marble deformation can be divided into four stages: compaction, linear elasticity, crack propagation and post-peak failure. Stress–strain curve is not obviously affected by temperature. Macroscopic fracture characteristics change from shear failure to tensile mixed failure with temperature increasing. With the increase of temperature, the strength of marble tends to decrease, indicating that temperature increase has a weakening effect on marble, and there are temperature-sensitive areas of 20–60 °C and temperature sub-sensitive areas of 60–120 °C. The elastic modulus of marble decreases and Poisson's ratio increases with increasing temperature. The energy evolution law of marble under different temperature is basically the same, which shows that before crack initiation, the energy dissipation is less, and after the damage and yielding occurs, the energy dissipation increases quickly. The energy dissipation in the failure process is mainly used for crack initiation-connection-penetration, as well as plastic deformation caused by friction and slip of cracks, and the plastic deformation and energy dissipation have good linear characteristics. The statistical damage constitutive model based on three-parameter Weibull distribution function can effectively reflect the characteristics of post-peak plastic deformation and strain softening. The weakening effect of marble at 20–120 °C is related to its internal moisture excitation. With the increase of temperature, water is stimulated to absorb and attach to the original relatively dry interface, which plays a role in lubrication. The relative motion friction resistance between solid particles or crack surfaces decreases, which leads to crack initiation and friction energy consumption reduction, changes the specific surface energy of rocks and weakens the strength of marble. The results provide a theoretical basis for predicting and evaluating the long-term stability and safety of surrounding rock of underground deep engineering in complex environment with high ground temperature and high geo-stress.

Temperature Fatigue Characteristics of Tile-Mortar Interface Based on Fatigue Cohesive Zone Model

Numerical Simulation on Damage Behaviors of Tile-Mortar Interface Induced by Mortar Shrinkage and Temperature Cycles

Mechanistic Modeling of Fatigue Crack Growth in Asphalt Fine Aggregate Matrix under Torsional Shear Cyclic Load

Multiscale Prediction of Thermal Damage for Hybrid Fibers Reinforced Cementitious Composites Blended with Fly Ash at High Temperatures

An elastic-plastic cohesive zone model for metal-ceramic interfaces at finite deformations

Damage Based Constitutive Model for Predicting the Performance Degradation of Concrete

Effect of interface damage on tensile behavior of fiber-reinforced ceramic-matrix composites after thermal fatigue loading

Experimental and Numerical Investigation on the Tensile Fracture of Compacted Clay

Change of the Coefficient of Thermal Expansion of Mortar Due to Damage by Freeze Thaw Cycles

Mechanical properties of thermally damaged mortar under coupled static-dynamic loading

Investigating High-Temperature Deformation Evolution of Concrete under Sustained Loading Using DIC Technology and a Temperature-Mechanical Coupled Damage Constitutive Model

A strength based thermo-mechanical coupled cohesive zone model for simulating heat flux induced interface debonding

A temperature-dependent constitutive model for fiber-reinforced ceramic matrix composites and structural stress analysis

Experimental investigations and micromechanical thermal fatigue models of concrete

Micro‐Thermomechanical Modeling of Rocks With Temperature‐Dependent Friction and Damage Laws

Cracking and thermal resistance in concrete: Coupled thermo-mechanics and phase-field modeling

Microstructural modeling of moisture-thermal and mechanical behavior within concrete during drying at elevated temperatures

A length scale insensitive phase‐field model for fully coupled thermo‐mechanical fracture in concrete at high temperatures

Fracture mechanism and constitutive model considering post-peak plastic deformation of marble under thermal–mechanical action

Modeling the Progressive Damage of Cryogenic Microdroplet Tests Using a Temperature‐friction Cohesive Zone Model

Modeling Moisture Transport at the Surface Layer of Fatigue-Damaged Concrete