Abstract:<p>Predicting the mechanical failure of parts in service requires understanding their deformation behavior, and associated dynamic microstructural evolution up to the near-atomic scale. Solutes are known to interact with defects generated by plastic deformation, thereby affecting their displacement throughout the microstructure and hence the material's mechanical response to solicitation. This effect is studied here in a polycrystalline Ni-based superalloy with two different Nb contents that lead to a significant change in their creep lifetime. Creep testing at 750°C and 600 MPa shows that the high-Nb alloy performs better in terms of creep strain rate. Considering the similar initial microstructures, the difference in mechanical behavior is attributed to a phase transformation that occurs along planar faults, controlled by the different types of stacking faults and alloy composition. Electron channeling contrast imaging reveals the presence of stacking faults in both alloys. Microtwinning is observed only in the low-Nb alloy, rationalizing in part the higher creep strain rate. In the high-Nb alloy, atom probe tomography evidences two different types of stacking faults based on their partitioning behavior. Superlattice intrinsic stacking faults were found enriched in Nb, Co, Cr and Mo while only Nb and Co was segregated at superlattice extrinsic stacking faults. Based on their composition, a local phase transformation occurring along the faults is suggested, resulting in slower creep strain rate in the high-Nb alloy. In comparison, mainly superlattice intrinsic stacking faults enriched in Co, Cr, Nb and Mo were found in the low-Nb alloy. Following the results presented here, and those available in the literature, an atomic-scale driven alloy design approach that controls and promotes local phase transformation along planar faults at 750°C is proposed, aiming to design superalloys with enhanced creep resistance.</p>

Defect Interactions and Formation of Nanometer Γ Phases Within Γ' Precipitates in Ni-Co-based Superalloys During Creep

Refining Micron-Sized Grains to Nanoscale in Ni-Co Based Superalloy by Quasistatical Compressive Deformation at High Temperature

Inconsistent creep between dendrite core and interdendritic region under different degrees of elemental inhomogeneity in nickel-based single crystal superalloys

Shearing Mechanisms of Stacking Fault and Anti-Phase-boundary Forming Dislocation Pairs in the Γ′ Phase in Ni-based Single Crystal Superalloy

Formative and controlled mechanisms of nano-sized γ′ precipitates with local phase-transition within dislocation networks of nickel-based single crystal superalloys

New Insights of the Microcrack Initiation Induced by Mo Addition in Ni-based Single Crystal Superalloys During Creep at 900 °C

Atomic Structure and Elemental Segregation Behavior of Creep Defects in a Co-Al-W-based Single Crystal Superalloys under High Temperature and Low Stress

Creep Behavior and Deformation Mechanism of a Third-Generation Single Crystal Ni-Based Superalloy at 980 °C

Coupling between Re segregation and γ/γ′ interfacial dislocations during high-temperature, low-stress creep of a nickel-based single-crystal superalloy

Segregation-assisted phase transformation and anti-phase boundary formation during creep of a γ′-strengthened Co-based superalloy at high temperatures

Elemental Segregation on Stacking Faults and γ″ Formation During Creep in 718plus Superalloy

Precipitate dissolution during deformation induced twin thickening in a CoNi-base superalloy subject to creep

High-Ti inducing local Eta-phase transformation and creep-twinning in CoNi-based superalloys

Creep properties and deformation mechanisms of single-crystalline $γ^\prime$-strengthened superalloys in dependence of the Co/Ni ratio

Microstructure Evolution and Dislocation Mechanism of a Third-Generation Single-Crystal Ni-Based Superalloy during Creep at 1170 °C

Deformation features of a nickel-base superalloy single crystal during compression creep

High-Temperature Creep Behavior of a Nickel-Based Single-Crystal Superalloy with Small-Angle Deviation from [111] Orientation

Effect of μ precipitation and γ′ evolution on intra/intergranular strength of Ni-Co-Cr-based superalloys after 800 °C thermal exposure

Enhanced creep performance in a polycrystalline superalloy driven by atomic-scale phase transformation along planar faults

Homogenization Effects by Co Additions to High Temperature and Low Stress Creep Performance of a 4Th-Generation Ni-based Single Crystal Superalloys

Influence of Γ′ Precipitates on the Critical Strain and Localized Deformation of Serrated Flow in Ni-based Superalloys