Abstract:Ni-based wrought superalloys are widely used in the hot section of aircraft gas turbine engines for their capability in retaining strength and resisting creep, fatigue, and oxidation at elevated temperature. With the development of the newer generation turbine disk alloys, it is highly imperative for aircraft engine manufacturers to substantiate the use of the materials by conducting a thorough examination of their mechanical properties. As these components are subjected to elevated temperatures and complex stress state in the service process where time dependent creep is the primary deformation failure mechanism and life-limiting factor for the component, it is of great importance to evaluate the relationship between microstructure, creep behavior and the underlying creep deformation mechanism. Therefore, the main objective of the present research aims at investigating the fundamental relationship between external creep condition and internal creep deformation mechanism in a new wrought superalloy with low stacking fault energy (SFE). In order to study the influences of the loading stress level and temperature on the creep deformation mechanism, stress range of 345-840 MPa and temperature range of 650-815 degrees C were selected to carry out the creep experiment. The results show that two kinds of gamma' with different diameters distributed in the matrix and the larger one began to coarsen when the creep temperature increased to 725 degrees C. Under creep temperature of 650 degrees C, the formation of SF resulted from the shearing of gamma' by dislocations dominated the creep deformation. When the temperature range was raised up to 725-760 degrees C, SF and microtwins were the main microstructures after creep deformation. With further increasing the temperature and load, instead of accommodating only in the gamma', the SF and microtwins penetrated the whole gamma' and matrix area. When the temperature was increased to 815 degrees C, the climb/bypass mechanism controlled the creep process.

Atomic Structure and Elemental Segregation Behavior of Creep Defects in a Co-Al-W-based Single Crystal Superalloys under High Temperature and Low Stress

Segregation-assisted phase transformation and anti-phase boundary formation during creep of a γ′-strengthened Co-based superalloy at high temperatures

Inconsistent creep between dendrite core and interdendritic region under different degrees of elemental inhomogeneity in nickel-based single crystal superalloys

Understanding creep of a single-crystalline Co-Al-W-Ta superalloy by studying the deformation mechanism, segregation tendency and stacking fault energy

Defect Interactions and Formation of Nanometer Γ Phases Within Γ' Precipitates in Ni-Co-based Superalloys During Creep

Superior creep resistance in a γ′-strengthened Co-based single-crystal superalloy at 760°C and ∼90% yield strength

Creep Mechanism of A Ni-Co Base Wrought Superalloy

Creep Behavior and Deformation Mechanism of a Third-Generation Single Crystal Ni-Based Superalloy at 980 °C

Elemental Segregation on Stacking Faults and γ″ Formation During Creep in 718plus Superalloy

In Situ SEM Study of Creep Deformation Behavior of Nickel-Based Single-Crystal Superalloys

Phase-field simulation of γ' precipitates rafting and creep property of Co-base superalloys

High-Ti inducing local Eta-phase transformation and creep-twinning in CoNi-based superalloys

Creep properties and deformation mechanisms of single-crystalline $γ^\prime$-strengthened superalloys in dependence of the Co/Ni ratio

Microstructure and Creep Performance of a Multicomponent Co-Based L1 2-Ordered Intermetallic Alloy

Crystal plasticity phase-field simulation of rafting and creep properties with a continuous change of the mismatch strain in a Co-Al-W superalloy

Enhanced creep performance in a polycrystalline superalloy driven by atomic-scale phase transformation along planar faults

Homogenization Effects by Co Additions to High Temperature and Low Stress Creep Performance of a 4Th-Generation Ni-based Single Crystal Superalloys

Crystal plasticity phase-field simulation of creep property of Co-base single crystal superalloy with pre-rafting

The Creep Deformation Behavior of a Single-Crystal Co–Al–W-base Superalloy at 900 °C

Creep Behavior and a Deformation Mechanism Based Creep Rate Model under High Temperature and Low Stress Condition for Single Crystal Superalloy DD5

Creep Mechanisms of a Ni-Co-Based-Wrought Superalloy with Low Stacking Fault Energy