Abstract:Ni-based wrought superalloys are widely used in the hot section of aircraft gas turbine engines for their capability in retaining strength and resisting creep, fatigue, and oxidation at elevated temperature. With the development of the newer generation turbine disk alloys, it is highly imperative for aircraft engine manufacturers to substantiate the use of the materials by conducting a thorough examination of their mechanical properties. As these components are subjected to elevated temperatures and complex stress state in the service process where time dependent creep is the primary deformation failure mechanism and life-limiting factor for the component, it is of great importance to evaluate the relationship between microstructure, creep behavior and the underlying creep deformation mechanism. Therefore, the main objective of the present research aims at investigating the fundamental relationship between external creep condition and internal creep deformation mechanism in a new wrought superalloy with low stacking fault energy (SFE). In order to study the influences of the loading stress level and temperature on the creep deformation mechanism, stress range of 345-840 MPa and temperature range of 650-815 degrees C were selected to carry out the creep experiment. The results show that two kinds of gamma' with different diameters distributed in the matrix and the larger one began to coarsen when the creep temperature increased to 725 degrees C. Under creep temperature of 650 degrees C, the formation of SF resulted from the shearing of gamma' by dislocations dominated the creep deformation. When the temperature range was raised up to 725-760 degrees C, SF and microtwins were the main microstructures after creep deformation. With further increasing the temperature and load, instead of accommodating only in the gamma', the SF and microtwins penetrated the whole gamma' and matrix area. When the temperature was increased to 815 degrees C, the climb/bypass mechanism controlled the creep process.

Elemental Segregation on Stacking Faults and γ″ Formation During Creep in 718plus Superalloy

New Insights of the Microcrack Initiation Induced by Mo Addition in Ni-based Single Crystal Superalloys During Creep at 900 °C

Shearing Mechanisms of Stacking Fault and Anti-Phase-boundary Forming Dislocation Pairs in the Γ′ Phase in Ni-based Single Crystal Superalloy

Inconsistent creep between dendrite core and interdendritic region under different degrees of elemental inhomogeneity in nickel-based single crystal superalloys

Creep Behavior and Deformation Mechanism of a Third-Generation Single Crystal Ni-Based Superalloy at 980 °C

Segregation-assisted phase transformation and anti-phase boundary formation during creep of a γ′-strengthened Co-based superalloy at high temperatures

Defect Interactions and Formation of Nanometer Γ Phases Within Γ' Precipitates in Ni-Co-based Superalloys During Creep

Stacking fault energy and creep mechanism of a single-crystal nickel-based superalloy

Atomic Structure and Elemental Segregation Behavior of Creep Defects in a Co-Al-W-based Single Crystal Superalloys under High Temperature and Low Stress

Microstructure Evolution and Dislocation Mechanism of a Third-Generation Single-Crystal Ni-Based Superalloy during Creep at 1170 °C

In Situ SEM Study of Creep Deformation Behavior of Nickel-Based Single-Crystal Superalloys

Creep behaviors of fine-grained Ni-base powder metallurgy superalloys at elevated temperatures

Coupling between Re segregation and γ/γ′ interfacial dislocations during high-temperature, low-stress creep of a nickel-based single-crystal superalloy

Dislocation Structure Due to High Temperature Deformation in Γ′ Phase of a Nickel-Base Superalloy

Creep Mechanism of A Ni-Co Base Wrought Superalloy

Effects of Stacking Fault Energy on the Creep Behaviors of Ni-Base Superalloy

Formative and controlled mechanisms of nano-sized γ′ precipitates with local phase-transition within dislocation networks of nickel-based single crystal superalloys

High-Temperature Creep Behavior of a Nickel-Based Single-Crystal Superalloy with Small-Angle Deviation from [111] Orientation

Effects of Stacking Fault Energy and Temperature on Creep Performance of Ni-based Alloy with Different Co Contents

Characterization of the Microstructure Evolution and Microsegregation in A Ni-Based Superalloy under Super-High Thermal Gradient Directional Solidification

Enhanced creep performance in a polycrystalline superalloy driven by atomic-scale phase transformation along planar faults